Powered Ceiling Hoist Solution for Lifting 300 lb Camper Shell
Published 04/14/2020
Products Featured in This Question
Question:
Thank you for your reply to my question concerning the BDW15008. The Buffalo Tools BTEHOISTUL hoist you referenced is a very good match for my application. My application works best if I mount the hoist at a different location than above the camper shell I am lifting. Can the hoist be mounted upside down (so it would pulling down)?
asked by: Brent T
Helpful Expert Reply:
We have a great powered hoist solution that has the capacity you'd need for your up to 300 lb camper shell with the Dutton-Lainson StrongArm Electric Winch w/ Remote and Pulley Block, AC Powered - 1,200 lbs Item # DL25727. The winch you referenced though is not rated for lifting anything off the ground and suspending it.
Product Page this Question was Asked From
Bulldog Winch Utility Winch - Wire Rope - 2,000 lbs
- Electric Winch
- Trailer Winch
- Planetary Gear
- 1.0 HP
- 1001 - 2000 lbs
- 21 - 30 lbs
- Slow - 0 to 4 fpm
- Plug-In Remote
- Wire Rope
- Bulldog Winch
more information >
Continue Researching
- Q&A: Using an Electric Winch to Raise and Lower a Ramp Door on a Logan Horse Trailer
- Article: Most Popular Wheel Bearings
- Q&A: How to Tell if a Trailer Spindle is Damaged or Needs to be Replaced
- Q&A: Electric Winch with Remote to Raise Rear Trailer Door
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Q&A: Do You Carry Just the Inner Portion Of The Dexter DX7.5L A-60 Brake Actuator For Disc Brakes?
- Q&A: Recommended Trailer Safety Chains for a 7,500 Lb Trailer
- Q&A: Tie Down LP7000 Brake Actuator Replacement
- Q&A: How to Replace Tie Down Engineering LP7000 Actuator
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Hand Winches
- Article: 5 Things to Know About Weight Distribution Hitches
Brent T.
4/14/2020
Thank you for your reply to my question concerning the BDW15008. The Buffalo Tools BTEHOISTUL hoist you referenced is a very good match for my application. My application works best if I mount the hoist at a different location than above the camper shell I am lifting. Can the hoist be mounted upside down (so it would pulling down)?