How Does Smart Fortwo Get Secured to Aluma Trailer Using E-Tracks

Updated 02/27/2020 | Published 05/18/2019

Products Featured in This Question

Erickson Horizontal E Track - Zinc Plated Steel - 2,000 lbs - 5' Long - Qty 1

(1201)

$42.84

Erickson Adjustable Wheel Net with E-Track Fittings - 1,166 lbs

(144)

$41.47

etrailer E-Track Backing Plates w/ Hardware - Galvanized Steel - 6" Long x 6" Wide - Qty 2

(238)

$17.93

Erickson E-Chock Wheel Chocks for E Track - Powder Coated Steel - Qty 2

(561)

$47.45

Question:

I see the picture from your post ... ez trailer parts 77314 and e19148 ... How are the most forward and back straps fastened? I suspect you use two 5 foot sections ... second question ... I have an alumina trailer with aluminum bed ... how do I secure the e track ... the videos o lay show fastening into wood studs.

asked by: Brandon

Expert Reply:

I attached the picture I believe you were referencing for securing a Smart car too a Aluma trailer using E-track. The straps used in the picture are the Erickson Adjustable Wheel Net with E-Track Fittings # 77314 which basically just snap into place into the slots of the E-tracks and then the ratchet tightens the straps to the tires. I also attached a second picture that shows a closer angle for you to check out to see more. We also have wheel chocks that fit into e-track as well that would be a really great idea. For that you'd want the part # EM09162-2.

I would use backing plates like the # e96RR on the underside of your trailer floor with carriage bolts and nuts when securing the tracks like # E19148 to your trailer.

expert reply by: Jameson C

click to enlarge

Travis B.

2/27/2020

I notice that in the second picture you attached, the back clip for the eTrack wheel net under the drivers door is pulling at a fairly strong angle. I was always under the impression that eTrack straps should only be used at a 90 degree angle to the track itself. Is it okay to pull at an angle like this?

Chris R.

2/27/2020

It's perfectly okay to have the tie-down straps being pulled at a steeper angle like on the picture you mentioned. If possible you want to avoid securing weight at a side-to-side/perpendicular angle from the e-tracks, but as long as it's still parallel to the track, they won't have any issue safely securing the vehicle (or any other cargo) in place.