Torque Spec for U-Bolts on a 2008 Toyota Tundra
Published 01/17/2019
Question:
What is the torque specs for U-bolt used to install sumo springs in the rear?
asked by: Nick
0
Expert Reply:
According to ALLDATA, when reinstalling the rear u-bolt for the SumoSprings Solo Custom Helper Springs part # SSR-610-47 on a 2008 Toyota Tundra you will need to apply 74 ft-lb of torque.
expert reply by:
Conner L
0
Product Page this Question was Asked From
SumoSprings Solo Custom Helper Springs - Rear Axle
- Vehicle Suspension
- Towing/Load Leveling
- Bump Stops
- Suspension Only
- Light Duty
- Rear Axle Suspension Enhancement
- SuperSprings Intl
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Leveling Aluminum Tongue Camper
- Q&A: Comparing Timbren and SumoSprings for The Rear Suspension of a 2021 Toyota Tundra
- Q&A: Looking For Torklift Camper Tie Downs For Ford F350 Long Bed
- Q&A: 2021 Toyota Tacoma Suspension Enhancement and Weight Distribution for a 2018 Airstream Basecamp 16
- Q&A: Recommended Rear Suspension Enhancement For 2022 Toyota 4Runner Towing 3,500lb Camper
- Q&A: Suspension Enhancement & Brake Controller Recommendations For 2006 Toyota 4Runner Towing Trailer
- Q&A: Will SumoSprings Increase Ride Height When Unloaded
- Article: Anti-Rattle Devices
- Article: Best Air Bag Suspension (2023)
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Determining Trailer Tongue Weight