Troubleshooting Error Code 150 on Edge Diesel Evolution CS2 Performance Tuner
Question:
Im getting an Error code #150. The Message on the screen says the programmer is not responding.
asked by: Tim L
Expert Reply:
I spoke with my contact at Edge regarding the 150 error code you're receiving with the Diesel Evolution CS2 Performance Tuner # EP85301. He stated that this error code essentially means that the tuner has lost communication with the ECM (engine control module).
He said that as long as your truck is fine (it can start and run) then the error code can usually be cleared by simply unplugging the tuner, letting it sit for a few minutes, and then plugging it back in. This should allow it to re-establish a connection with the ECM.
If this does not resolve the issue then the next step would be to contact Edge directly and they will be able to send some recovery software files to the system to get it back up and running.
Product Page this Question was Asked From
Edge Diesel Evolution CS2 Performance Tuner - Color Screen - CA Approved
- Performance Chip
- Performance Tuners
- Tuner Only
- Color Screen
- Yes - California Approved
- Evolution
- Edge
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Recommended 2-1/2 Inch Trailer Hitch for 2008 Chevy Silverado 2500 with Best Ground Clearance
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Q&A: Distance Between Mounting Holes of Draw-Tite Hitch DT45519
- Q&A: Are All Brands of 7-Ways Equal or Are There Better Options
- Q&A: Distance from Bumper to Top of Curt Trailer Hitch C15703 on a 2005 Chevy Silverado 2500
- Q&A: Recommended Heavy Duty Hitch for a 2006 GMC Sierra Short Bed
- Q&A: Replacement Follower Leg for a Venture VMC900L Landing Gear Set