Replacement Ladder for a 2004 Monaco Dynasty

Question

Question:

My ladder on my coach the support brackets are becoming rusty and I think I need a new ladder. The original is made by Christianson. Do you carry this

asked by: CHuck G

0

Expert Reply:

I may have an alternative solution for you, but we do not carry any ladders made by Christianson.

We do carry the Stromberg Carlson RV Exterior Ladder w/ Hinges, part # LA-401 for Silver or part # LA-401BA for Black, which is a universal fit ladder. It is 99-1/2" tall x 12 " wide but has a customizable height - you just need to trim the length of the ladder to fit your application using a hacksaw or tube cutter.

I have attached a picture giving the dimensions of the ladder as well as a review video for you to check out.

expert reply by: Jon G

0

click to enlarge

Answer 1

I spoke with the manufacturer, Lippert, and the correct replacement for a Power Gear 532049 slide-out motor is the Replacement Teardrop Gear Motor Assembly for Lippert Slide-Out #LC56JJ.

view full answer...

Answer 2

I recommend replacing an entire ladder if it's damaged. You'll want to find a replacement based on the height. Such as the Stromberg Carlson #LA-401 that is 99-1/2 inches tall. They can be cut shorter to customize the length if needed.

view full answer...

Answer 3

Thank you for the drawing. It was helpful to see the dimensions you are looking at. We only have one ladder that is a universal fit application, so it will fit your RV but it will not fit in a custom way. It will absolutely be able to give you a…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Hey Michael, Yes, the Hellwig Front Anti-Sway Bar #HE43RR is the same thing as the 7217. We just have to have different part numbers because multiple vendors will all use the same part numbers.

view full answer...

Answer 7

Both the Curt #C13382 and the etrailer #e98912 hitch are a 2" Class III hitch receiver that will provide a maximum gross trailer weight of 3,500 lbs and a maximum tongue weight of 525 lbs. You are correct, they are an identical hitch but our…

view full answer...

Answer 8

We have lift kits for trailer that easily add 2 inches to the height of the trailer. For that you'd want the part #RR23QX and you'd be set. I attached a picture that shows how it installs to give you an idea. This would be the easiest…

view full answer...

Answer 9

Increasing the tire and wheel size can increase the height of the trailer but it's usually quite minimal. Before you do anything else you should see if the pin box can be adjusted. Although you have to be careful here since This will lower the…

view full answer...

Answer 10

Hey Christopher, Does your Lantern have a leaf spring suspension or torsion axle suspension? If you have a leaf spring suspension and your axle sits above the leaf springs then you can use an over-under-conversion kit #K71-384-00 (2-3/8"…

view full answer...

Replacement Ladder for a 2004 Monaco Dynasty

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching