General Motors Truck Cap Wiring for Third Brake Light
Updated 07/25/2017 | Published 07/22/2017
Question:
According to the pictures, I found the little blue wire, it actually has a factory installed plug on it, but, my truck cap brake light has two wires. Where do I connect the other wire?
asked by: Stephen
0
Expert Reply:
One wire on the truck cap is to power the light and connects to the blue wire you found. The other should be a ground and needs to be connected to a clean, bare metal surface.
expert reply by:
Charles S
0
click to enlarge
click to enlarge
Product Page this Question was Asked From
Pollak Replacement 7-Pole, RV-Style Trailer Connector Socket - Vehicle End
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- 7 Blade
- Plug Only
- Pollak
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Determining Trailer Tongue Weight
- Q&A: What is the Difference Between 7-Way RV and Utility Trailer Connectors
- Q&A: Need Light Kit And License Plate Holder For Hollywood RV Rider Bike Rack
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Tip for Installing SmartPlug RV # SM96FR
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Q&A: Replacement Connector for a Pollak PA66-MD40
- Q&A: Recommended 7-Way Connector for a 2020 Ford Escape
- Q&A: When Truck is Put in Reverse the Trailer Brakes Lock Up
- Article: 2005-Current Volkswagen Touareg, Audi, or Porsche Cayenne