What Are the Dimensions of Dutton Lainson Pipe Mount Swivel Jack When Extended and Retracted  

From the center of the pipe mount to the top of the etrailer jack #TJP-2002-Z measures 4-1/4 inches.

The Vision X Utility Market Floodlight #XIL-UF32 that you referenced is waterproof and puts out 500 lumens so it would do an excellent job as a reverse light.

The issue is that there is a screw inside the jack that turns in either direct to raise or lower the jack. It threads through a fixed nut. At the very top of the screw the threads are all mashed up so that the leg can't just fall out. Basically…

I took some measurements of the Dutton-Lainson Pipe Mount Swivel Style Trailer Jack with Foot item #DL22682. The bottom of the handle sits right at 11" above the center of the mounting tube. This jack has our largest length between the pipe…

The correct slide-out toppers for your 2021 Grand Design Reflection is the Solera RV Slide-Out Awning #LCV000177334 that will fit slide outs that are 140-145 inches wide and 48 inches long, and Solera RV Slide-Out Awning #LCV000168109 that fits slide…

My research indicates that grease seal part 125255UC has an outer diameter of 1.980-inches and this correlates with the hubs that use bearing #L44649. The seal part most often used with inner/outer bearing L44649 is seal part #10-9 which has an inner…

A TruRyde rvd-h-865 7k hub/drum like # AKHD-865-7-2-K uses 1/2-inch drive-in studs that are 1-5/16-inches long. For a replacement stud you can use #165981. This is slightly longer at 1-1/2-inches but it has the same 1/2-inch diameter. They are also…

I recommend the Solera RV Slide-Out Awning - 13'1" Wide - 48" Projection #LCV000168109 which will fit RV's with slide outs that are 152" to 157" wide and up to 48" long, the awning rail is included. This is also…

Hey there Gary, thanks for the photo and yes the etrailer Bolt-On Swivel Mounting Plate for 3,500-lb Trailer Jacks with a 5/8" Swivel Pin #e52JR will indeed work with your Round, Pipe Mount Swivel Jack #TJP-5001S-B.

I went out to the warehouse and measured a T-Handle Locking Stainless Steel Flush Door Latch, #L4080. The overall depth is 2-3/4 inches. The latch on the back side is adjustable and will fit on a door that is a 1-3/8 inches thick to 1-11/16 inches…

According to my Redline representative, all of the #L4080 T-Handle locks are keyed alike. I have confirmed this myself by pulling a few of them off the shelf in the warehouse. They all use the same key number, so if you order four of them, they will…