Feature Review Master Lock Trailer Hitch Receiver Lock Video

There are adapters on the market that can go from a cigarette lighter style plug that the #C-FOS07TAPK-006 has to USB/USB-C ports but we don't currently offer any so the only solution I can provide is the #RM-9332. This is a replacement outlet…

Thanks for reaching out, i have a couple things for you to do. Let me explain below: *12V PWM Filter for RV Backup Camera Systems - Hardwire #VGR64VR. The newer GMC vehicles use PWM(Pulse With Modulation) in their electrical systems. The Furrion…

This will depend on the hitch used and the height of the trailer coupler. You want the trailer to be as level as possible. We have a page on calculating hitch height and coupler height to help you find what ball mount would work best. Most light duty…

If you check out the picture I attached you will see where I pointed out where the sticker is that has the VIN on the Yakima Rack and Roll trailers like the part #Y08106. If somehow the sticker is worn off or unreadable my contact at Yakima said that…

I went out to the warehouse and pulled Curt trailer hitch ball #A-82 to measure it for you. The height from the mounting surface to the top of the ball is 2-3/4 inches. I have included a picture showing this measurement.

To replace the hitch ball you would simply loosen and remove the hitch ball nut and pull the ball out of the ball mount hole. You may need a large wrench to loosen the nut. The Tow Ready 1-7/8 Inch Hitch Ball, part #19260, would be a great fit for…

From the center of the pipe mount to the top of the etrailer jack #TJP-2002-Z measures 4-1/4 inches.

The Vision X Utility Market Floodlight #XIL-UF32 that you referenced is waterproof and puts out 500 lumens so it would do an excellent job as a reverse light.

When the Pipe Mount Swivel Style Trailer Jack with Foot - Topwind - 15" Travel - 2,000 lbs. #DL22682 is fully extended the distance from the center of the weld-on spud to the foot is 29-3/4 inches. When this is fully retracted the distance is…

The black box that you are referring to on the Hopkins Plug-In Simple Wiring Harness #43365 is a tail light converter. This is used to ensure that your Tundra's wiring will match that of your trailer. Your 2000 Toyota Tundra uses a separate…

The Curt T-Connector Vehicle Wiring Harness, part #C55367 is designed to fit the 2000 Toyota Tundra. The connector the harness attaches to is located behind the rear bumper. I have attached a photo that shows where the vehicle plug is located. In the…

I have attached a video of the etrailer.com Trailer Hitch Receiver part #e98903 installed on the 2020 Chrysler Pacifica. We do have a video of an install on a 2018 which would be the same as your 2020 Chrysler Pacifica. The underbody panel does need…