Customers compare A35W42B to these similar products
Products Featured in this Video
Today on our trailer, we'll be doing a rewire using the 35' Wishbone 4-way trailer wiring harness with 42" ground wire, from Optronics, part number A35W42B. Now we went ahead and already removed all the old wiring on this trailer before we began this video. So now we're ready to start with a clean slate. To begin with, we're going to go ahead and tape the two ends of the wiring together to make it… see more >
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Videos
Help Articles
Expert Answers
Since your tandem axle trailer only has brakes on one of the axles, you will just need a single axle kit like the Kodiak Hydraulic Brake Line Kit #18SI-BLKIT you were looking at. This kit includes an 18 foot, 7 foot and 1-1/2 foot long flexible…
view full answer...We have some hubs that can replace the 5-Spoke utility-style you're currently using, but they use a 6 lug pattern which actually works out because you'll need to replace your wheels for your tires anyways. To increase your tire size…
view full answer...Thanks for the photo. You will not have any issue using the Dexter Heavy-Duty Suspension Kit for Tandem-Axle Trailers - 1-3/4" Wide Double-Eye Springs #K71-449-00 and moving the equalizer bolt down to the lower hole position. This will work very…
view full answer...As you noted, the typically wiring colors for a 4-Way connector is white for ground, brown for tail/running, yellow for left stop/turn, and green for right stop/turn. The confusing part is that even though this is the typical way that the wiring is…
view full answer...At one time, wobble roller was a patented term, but now the term wobble roller and rocker-roller are interchangeable. The #DL21564 roller you mentioned has an integrated bushing that makes the roller track straight on the shaft it's installed on,…
view full answer...Typically trailer wiring is color coded. The brake circuit is usually a blue wire which travels to each brake magnet, where it is attached to one wire from each brake magnet. The other wire from each brake magnet will ground to the trailer frame. I…
view full answer...It could be a tow package fuse on the vehicle. Use the owners manual to find the locations of fuses/relays related to the tow package wiring to check them and replace as needed. If the issue is not a fuse or relay then you can test the vehicle side…
view full answer...The gauge of the wiring in the 4-way kit part #A35W42B is 18 gauge.
view full answer...The Bonded 4 Wire - per foot #16-4B-1 you asked from would use the brown running light wire for your clearance/marker lights. The LED light you referenced sound like they have two wires so one will be power and the other ground. You can connect them…
view full answer...This Submersible LED Trailer Light Kit with 25 foot Wiring Harness, part #TLL9RK, uses all stainless steel mounting hardware. The mounting hardware of this trailer light kit should work well in the saltwater conditions that you use your boat in.
view full answer...Yes. There's no reason you can't use something like the Quick Splices - Self-Stripping Connector - Closed Port - 14-16-18 Gauge - Blue - Qty 1 #SWC502905-1 to install the #W002230 on your trailer. The #W002230 uses 18 gauge wiring, so the…
view full answer...Yes, you can jump the front axles brake output circuit to power the rear axle. Check out the picture I attached to see how most people do this.
view full answer...