Front Hitch Recommendation for 2010 Chevy Tahoe  

The Draw Tite hitch part #65052 is a confirmed fit for your 2007 Chevy Tahoe and will bolt right up to the frame without any modification. It does drop down 7-3/4 inches from the frame where it attaches as well like you mentioned.

I spoke with my contact at Curt and he told me that there is only one mounting option for the Curt Front Hitch, #C31012. This hitch was designed to mount to the underside of the frame rails, hanging below the frame as it is pictured (see photo). He…

The Curt Front Mount Trailer Hitch, item #31302, is designed for a no drill application on the 2003 Chevrolet Tahoe 1500 Series. According to the instructions, if you install the hitch in the through bumper configuration you will need to cut a 3 inch…

Check out the picture I attached. In it you can see that the hitch opening will be right at the same distance out as the bottom of the license plate. I don't have an exact number I can give you but this would allow you to measure from the bumper…

You are going to have to trim out a section of your front air dam to install the Curt Hitch part #C31073 that is 3 inches wide by 1.50 inches tall. A similar amount of trimming is required for the Draw Tite hitch part #65064 as well. The other option…

I reached out to a representative of Draw-Tite who explained that the front mount trailer hitch #65052 that fits your 2014 Chevy Suburban LTZ will require trimming "up to the bottom of the bumper fascia" and sent the accompanying photo…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…