How to Pick Out Replacement Hubs and Over Under Kit for a Trailer
Question:
Would appreciate help with trailer brakes/drums replacement. I have axle and hub information currently installed. Including picture of suspension as I am considering relocating axle from riding on top of spring to under spring. Thank You,
asked by: Lee S
Expert Reply:
In order to pick out the correct hub assembly for a trailer you are going to need know a few key pieces of information. The first thing you will need to know is the bolt pattern of your hubs. This is so you get a hub that is compatible with your wheels. I attached an FAQ article on determining bolt pattern for you to check out.
Next thing you will need to know is what spindle you have on your trailer. In order to do that you can either get the inner and outer bearing numbers from a hub or use a dial caliper to get exact measurements of the spindle. The measurements needed are the parts of the spindle where the bearings ride.
If you get back to me with that information I will help you pick out the right hub assemblies. Or, you can follow the link I attached that will take you to the page that has all of our replacement hubs.
You would want to first select the bolt pattern that you have, next select the inner bearing you have, followed by selecting your outer bearing, and then all the correct hubs will be listed.
The diameter of your trailer axle will determine the size of the parts that you will need to order. If your axle is 3 inches diameter, the Dexter Trailer Springs Over-Under Conversion Kit, # K71-385-00, would be a great choice and if your axle is 2-3/8 inch diameter you could use the Over-Under Kit, # K71-384-00. These kits can be installed without welding but the manufacturer strongly recommends having the new spring seat tacked in place on the other side of the trailer axle.
Products Referenced in This Question
Dexter Trailer Springs Over-Under Conversion Kit
- Trailer Leaf Spring Suspension
- Alignment and Lift Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Round Axle - 3 Inch
- Dexter
more information >
Product Page this Question was Asked From
Dexter Trailer Springs Over-Under Conversion Kit
- Trailer Leaf Spring Suspension
- Alignment and Lift Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Round Axle - 2-3/8 Inch
- Single Axle
- Dexter
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: How to Raise Your Travel Trailer Height
- Article: Trailer Tire Sizing
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Slipper Spring Trailer Suspension System Review
- Article: Double-Eye Trailer Suspension System Review
- Q&A: Would Dexter 3,500 lb Axle Made in 1999 Use Same Hubs as Current
- Q&A: Is There An Axle Flip Kit for a 2,000 Lb 1-3/4 Inch Diameter Axle
- Q&A: Breaking In Replacement 6,000 lbs Leaf Springs
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Q&A: Double Eye Leaf Springs For Tandem Axle Trailer With 10,500LB Rating and 24" Length on Spring
- Q&A: How to Raise a 5th Wheel Trailer so it Rides Level
- Q&A: Will Flipping Axles on a Trailer Cause any Problems
- Q&A: Leaf Springs and Over Under Kit that Fits 2009 Jayco Eagle Super Lite 29.5 RKS