To see if this custom-fit item will work for you please tell us what vehicle you'll use it with.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
Quickly and easily install a 4-way trailer connector on your Toyota Prius with this custom wiring harness. T-One connector plugs directly into existing wiring - no cutting, splicing or tapping required. Powered ModuLite reduces strain on wiring system.
Features:
Specs:
Installation
This custom-fit T-One connector plugs into your vehicle's wiring harness, which is located inside your trunk, behind the tail lights on both the driver's side and passenger's side. You will need to remove some interior trim or carpeting to access the harness. Once you've plugged in the T-connector, run the wire with the fuse holder to your car battery and connect it to the positive terminal. Then insert the provided fuse into the in-line fuse holder.
Once installation is complete, the 4-way flat connector will be stowed within the spare tire compartment of your trunk.
It is recommended that you use a small amount of grease on all electrical connections - the plugs on your automobile and the 4-pole connector itself - to help prevent corrosion.
A ModuLite power module is built into this T-One connector. Because most trailers run on a two-wire system - wherein the brake and turn signals are carried on one wire - the separate brake and turn signals from your vehicle's three-wire system need to be combined so they are compatible with the wiring system of your trailer. This power module functions as a tail light converter to combine the brake and turn signal functions of your automobile so that they run on one wire to properly activate your trailer's tail lights. Note: This will not affect how the tail lights on your vehicle operate.
With a ModuLite, your trailer's lights will be powered without overloading your vehicle's electrical system. Because the module draws power directly from your car's battery and bypasses the electrical routes that are used by a basic wiring harness, there is virtually no draw on your tail light circuits.
California residents: click here
Average Customer Rating: 4.9 out of 5 stars (145 Customer Reviews)
Quickly and easily install a 4-way trailer connector on your vehicle with this custom wiring harness. T-One connector plugs directly into existing wiring - no cutting, splicing or tapping required. Powered ModuLite reduces strain on wiring system.I received my plug-in harness for my 2015 Prius. The quality is excellent and it went in without a hitch. Very impressed not having to cut, solder or shrink wrap. That is a big plus not dealing with those situations.
I buy from no one else. My first hitch assembly was for my old 2008 Prius. I got into ATVs during that time and I only had that Prius, and it worked flawlessly. I, however, put that poor car through hell, lol, and eventually the engine gave up on me, so I purchased a 2012 Lexus RX450h AWD, to handle my newly acquired outdoor hobby. I got a hitch assemble again from etrailer for sais Lexus, and it has worked flawlessly as well. Thank you etrailer for making affordable and durable hitches and wire hardnesses.
Order arrived as specified, and was exactly as described! I am very impressed with how well designed and constructed to be an "exact fit" for our 2015 Toyota Prius! I ran into some difficulty and wound up removing the rear bumper skin to install 2 nuts inside the frame of the vehicle because the vehicle had been in an accident, and apparently the body shop facility that repaired the car (prior to our ownership) neglected to replace the weldnuts!
It was still an easy install, just required a little more time, and effort due to no fault of ETrailer or the manufacturer of the hitch.
The wiring harness setup that ordered greatly simplified the light hookups, and was great quality! Exactly as described!
I would definitely order again, and I highly recommend ETrailer, and their products!
super easy to install. All the parts went together and work perfectly.
Keep up the good work and I will, as I always do, use etrailer.com for my needs
Glenn
7/23/2023
Great
The light kit and the trailer hitch installed quickly, and fit correctly. It took me about 30 minutes to install which included cleaning out under the trim areas.
Plug n play. Directions were easy to follow and the harness operates as it should.
Your pics were right on! It took about 15 to 20 minutes to hook up/install. Worked like a dream on my 1959 Elgin /JC Higgins tent trailer. 2008 Prius. Thanks again!
I have purchased 4 etrailer hitches& wiring harnesses. They have all performed flawlessly.
Because the taillights on my Prius run on low wattage LED bulbs, I couldn't just tap into the existing wires to run my trailer lights. I researched what would work and was happy to find the best solution was the wiring harness sold by etrailer. They work great.
Chuck W.
9/30/2015
After a year of use the wiring harness still works great.
The light wiring was easy to install, even for a non-car person like myself. The hitch went on, was a little tougher but that was because it was a bit heavier but I managed it by myself (and a floor jack). In all this was a great purchace and would recommend them for all your hitch/wiring needs. This reciever hitch and wiring went on a Toyota Prius.
Dave C.
4/25/2013
Has anyone successfully installed this on a 2013 Prius. I have a 2013 Prius III.Thanks
Patrick B.
4/25/2013
Simple!! plug and play on my 2012 prius 4. Hardest was not breaking the plastic clips for the covers.
Jason
11/9/2020
Works great in my 12 Prius four. No problems simply installed.
Shipping was quick. I ordered a hitch and harness to get free shipping. I'm not very mechanically inclined, but installing the harness was pretty easy, once I got the grounding wire screw to bite (had to screw my body into position first).
J T.
6/27/2014
Having used the trailer wiring and hitch a few times over the past year, I am quite satisfied with both. In the installation of the wiring, I was unprepared in that the process messed with my electronic door locks and I had to get them reprogrammed. Otherwise, no problems.Thanks again!
The wiring package instructions were easy to follow and the harness was the correct length to attach each connection. I am still using it today with no issues. I would recommend this to anyone with medium or higher skill abilities working on automobiles . Great product !!!!!!
Thanks,
Steve
Steve S.
6/13/2017
Still performing perfectly !!!!!
The product is excellent. I had a tow-bar outfit put it in as I'm too old to do that myself, but I did put in the wiring harness without trouble.
Steve T.
9/29/2017
Just fine
I watched the installation video twice and then installed my wiring harness to my 2010 Toyota Prius in 15 minutes. There was no two-faced tape for the power brick but there was a hole in the plastic casing for screwing it to a side panel. I probably spent 5 minutes finding a metal screw in my toolbox...so it was really about as 10 minute job. I purchased my hitch mount, hitch ball, and wiring harness from eTrailer.com and everything fit perfectly, works perfectly, and I could not be happier with the products.
The Hitch and Wiring Harnes were every thing I had hoped for.
The quality was very good an the installation went very well
without any problems.
Thank you
Henry F.
2/3/2015
I am still very pleased with both products, andwill be pleased to shop with you if I have a needfor any of your products.Henry F.
This works as advertised. With the quick connects the whole thing takes less than 10 minutes to install. It powers the lights on my trailer brightly and correctly. It does not require the rewiring that the factory Corolla kits does.
You need to mount the blackbox on the right near the 12v battery as the wires for the right tail lights are a bit short. You'll need a 10mm and 12mm socket to connect the power and ground leads.
The only improvements I can envision would be the integration of some diagnostic LED so you can quickly verify proper operation, and inclusion of a properly sized grommet for the wheel well drain hole. The printed instructions are hard to follow, but also mostly unnecessary as it only really fits one way.
Otherwise this kit it nearly perfect.
I haven't had one iota of issues with my wiring harness. It was amazingly easy to install and I am grateful for it! Thanks you.
Mari L.
4/30/2018
I love my trailer hitch! I have told many people about how easy it was to install and how etrailer is the best, giving excellent advise on how to install, customer service, and price. I am thinking of selling my car and getting one that can tow my little tear camper better and I thought of you if the vehicle I purchase doesnt already have a tow hitch.
It worked well. The only problem is I reversed the blinking side! Easy to fix that.
This was not difficult to install in my Prius but there are several steps involved and a couple of little puzzles to solve that aren't covered in the directions, so overall, I spent an hour or so on it. The trailer lites all worked as expected and they now shine brighter than when I've connected it to my pickup.
I've not had a tow vehicle before with trailer wiring that had supplemental power to the trailer lites as this wiring harness provides and I imagine that's a good thing from a safety standpoint. It'll be interesting to see if the bulbs in the trailer lites burn out quickly or not.
The installation puzzles I had to solve were a) How to disconnect the wiring harness plugs to the existing wiring to the car taillites without damaging that wiring, and b) How to connect the wiring to the battery.
To separate the existing wiring harness, one has to find a way to pry the plastic catch out from the block while simultaneously pulling the two pieces apart. The existing wiring provided by Toyota was such a surprisingly small diameter that I feared it would break if I pulled on it. I found needle nose pliers worked fairly well to grasp and pull on the plastic plug, but due to the awkward location and small amount of play in the wiring, serious contortions were required, at least for this old man.
Connecting the new harness to the Prius battery was complicated by the safety cover on the positive terminal. I never did figure out how to remove that cover, but found that it could be bent out of the way temporarily so that the connection could be loosened with an extended socket.
One surprise was that when completed, the Prius again started beeping loudly when put it in reverse. (Soon after I bought the car, I had turned off that beeper.) But going thru the same routine to turn the beeper off was again successful, so no biggie.
So overall, I'm glad I bought this wiring harness. Connecting it was probably simpler that splicing into the car's wiring directly and perhaps it was safer, too.
Directions clear. Installation 1/2 hour. Works!
Installed a 1.25" receiver hitch at same time. The receiver hitch took about 3 hrs to install because I twisted off a mounting bolt while removing the factory tie downs on this 8 year old Prius with 150,000 miles on salty Wisconsin roads.
Intend to use pulling a very light trailer for surf boards and bikes behind 2006 Prius.
High quality and easy to set up. Customer service is outstanding! At first I thought there was something wrong because the lights weren't working on the trailer. I contacted customer service, and within minutes I was connected to a highly certified service rep who really knew her stuff!! She instructed me to check the ground connection on the trailer for rust. I did and sure enough the connection was rusty. She then instructed me to use a file to remove the rust. I did so; and then reconnected the wires. After that it's worked perfect ever since! Thank you =)
wiring harness for my 2011 Prius trailer hitch arrived with trailer hitch in a very timely manner, the installation process was remarkably simple. I was very impressed with the ease that I was able to install the wiring harness. Great item.
I had ordered the wrong one. When I called they were more then helpful find the right part. Then I received it two days later. They also provided full refund on the first part (minus shipping) it wasn’t even there fault. So I would say they are very good company to work with. And I will tell everyone I know
Curt C.
7/14/2020
I have had the hitch for a year now. And I have had no problems with it at all. It still looks new. Thanks for a great product
Worked as expected thanks
Do you have a question about this Custom Fit Vehicle Wiring?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thomas V.
8/7/2023
This wiring harness has not given me any problems after using it for one year.