Jeep JL Wrangler Unlimited Spare Tire Bike Racks

The Thule Spare Me Bike rack part #TH963PRO and the Yakima Spare Tire part #Y02599 both do come with locks to secure the rack to your spare tire and cable locks to secure the bikes to the carrier. The biggest difference between the two and is only…

To move the arms you just need to push up on the spring loaded bolts to release the arms and swing them into place. That will move the arm up and allow you to move it freely back and forth. When you release the end of the arm with the nut and…

For a 2012 Toyota RAV4 with the spare tire mounted on the back door, you will want the EcoHitch #306-X7152. This hitch has an extended receiver and is made specifically for vehicles with the spare on the back.

Yes and no. The RockyMounts AfterParty Swing Away Bike Rack #RKY37ZR can be used if your bike has a smaller fender, but if it's a larger fender that covers most of the tire then it won't work as the clamps will damage the fenders.…

Good morning, Crystal. We can certainly provide you with three of the TCL65 Trimax Trailer Wheel Chock and Lock #TMX75FR. That said, we do not offer a "keyed alike" option for these locks, nor can we guarantee a specific key number.…

The 205/65-10 and the 20.5 x 8-10 would be very close in size. Assuming that 20.5 is the diameter of the tire and 8 is the width. The Kenda 205/65-10 Bias Trailer Tire with 10 inch White Wheel, #AM3H390, for example, is 8.3 inches wide with a…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

I had our warehouse measure the mounting studs on the HappiJac Manual Truck Camper Jack System - 36-1/2" Lift - 11,200 lbs #LC736515-4 you mentioned and found that they are 7-1/4" apart on center. I included a diagram of this…

The backing plate of the Surco Bike Rack part #BT300 that you referenced attaches to the rim by it sliding over the mounting plate for the wheel and then using the lug nuts that attach the wheel to the vehicle as a way to secure the wheel and the…

For a cargo carrier holding a generator at the back of a travel trailer I definitely recommend installing a frame mounted trailer hitch. It is unlikely that a bumper will be rated high enough to carry the generator and carrier and be able to…

According to Yakima, the SpareTime Bike Carrier should NOT be used on towed trailers or campers. The combined weight of the bikes and the rack is not really the issue, rather the fact that the rack will be subject to the additional jarring and…

For your 2018 Jeep JL Wrangler, I recommend using a weight distribution system, the Husky Center Line Weight Distribution part #HT32215 for 2" hitch ball or part #HT32216 for 2-5/16" hitch ball. The main reason I recommend a…