Hey Steve, thanks for reaching out! Yes, the Draw-Tite Sportframe Trailer Hitch Receiver #24978 will fit your 2025 Volkswagen Jetta GLI with the dual exhaust just fine. What do you plan on using the hitch for?
Yes, the T-One Vehicle Wiring Harness #118791 will fit your 2019 Volkswagen Jetta GLI. The description is saying basically it will fit all models of the 2019 Volkswagen Jetta.
Thank you so much for the photo it was very helpful! And since your 2019 Volkswagen Jetta has the faux dual exhaust which is just a trim and is not truly dual exhaust, you can absolutely install the Draw-Tite Trailer Hitch Receiver #24978. I have…
In order to narrow this down I would start by checking the vehicle side of the connector. Check and see if there is power using a circuit tester like the #PTW2993. If you find that there is power then you can rule out anything on the vehicle side and…
We do have a hitch that will fit the 2021 Jetta GLI. It looks like the GLI has dual exhaust and the Draw-Tite Sportframe Trailer Hitch Receiver item #24978 is the only one that is compatible with it. I like this hitch because it mounts behind the…
Welcome back Peter! For your 2024 Volkswagen Jetta GLI with dual exhaust the correct hitch is the Draw-Tite item #24978. This hitch is the only one that fits the GLI's with dual exhaust. It mounts behind your rear bumper cover instead of below…
There are a couple of trailer hitches that are a fit for your 2019 VW Jetta, the Curt Trailer Hitch Receiver #C11540 and Draw-Tite Trailer Hitch Receiver #24978. Both are Class I, 1-1/4 inch hitches, but between the two I strongly recommend going…
There are both Class I and Class III trailer hitches available that are confirmed to fit your 2010 Honda CR-V. The available Class I hitches, such as the Draw-Tite Sport Frame #24792, feature a square tube design, while the Class III hitches like the…
Both of the hitch options for your 2019 Volkswagen Jetta have the same capacities (but please do check your owner's manual for your Jetta's towing capacities) of 2,000 lb towing and 200 lbs tongue weight. So the only difference between the…
Monty, the first thing I'd do is make sure everything is plugged in properly and the connectors aren't damaged in any way. The next thing, and honestly the last thing you can check is the fuses. Since the T-One Vehicle Wiring Harness with…
Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…
Is it possible your FrontLoader was built after 2016 which would mean you'd need the knob part #8880766 which has a different nut in it and would explain why the older knob #8880266 isn't threading correctly.
