Custom Fit 2014 GMC Sierra 1500 Accessories

To determine if a 2009 Chevrolet Silverado 1500 with a 5.3L V8 can tow your 2002 Coachmen travel trailer, you will need to find the towing capacity of the truck and weight of your trailer when it is loaded and ready to tow. I did some research on the…

We do have a solution for you, however, you will not be able to power reverse lights on a trailer with a 4-pin trailer connector. The reverse lights on a trailer must receive power from the reverse lights on the tow vehicle. To do this, you will want…

For an amazing replacement for your Fabex MDL 665 pinbox, I recommend the Gen-Y Hitch Shock Absorbing 5th Wheel Pin Box #GY65SR. The Gen-Y pinbox is designed to fit the bolt pattern of your fifth-wheel trailer. As far as capacity, it has a really…

Since you actually have a Lippert 1116 pin box, the Gen-Y Hitch Shock Absorbing 5th Wheel Pin Box #325-GH-8040 that you ordered, which fits a 1621 pin box, is not going to work with your Keystone Fuzion 403 since the two pin boxes are not…

Ideally you want your trailer to be towed as level possible and still have at least 6 inches of clearance between overhang of the trailer and the bed rails of the truck. Since trucks tend to keep getting built taller and taller this can prove to be…

To install the Thule Caprock L in a set of roof rack tracks on your Leer cap you'd just need the feet kit part #TH460R and the fit kit part #THKIT3101.

I spoke with Progressive Dynamics about this question and they said that the Progressive Dynamics Inteli-Power RV Converter and Battery Charger #PD912524LV that you referenced can draw power from a modified sine wave inverter but wanted to make sure…

The brake controller jumper wire you found in the glove box can be used to wire in the brake controller you have. I am not sure which controller you have but basically you'll plug the harness into the port under your dash for the brake controller…

Tracks can absolutely be installed on the roof of your A.R.E. Truck Cap to provide a mounting system for a roof rack. For this I recommend the Yakima Tracks, which come in 42 inch #Y01126, 54 inch #Y01127, and 60 inch #Y01135 lengths. These tracks…

The correct replacement rear header for your TruXedo Lo Pro tonneau cover is the Replacement Rear Header for TruXedo Lo Pro Soft, Roll-up Tonneau Cover #TX5725-RearHeader.

It is very easy, as you just use the included clamps to secure the Caprock to your roof rack crossbars. The clamps are secured to the channels under the platform, and can be positioned wherever needed to accommodate the spacing of your crossbars. And…

The Replacement Tailgate Top Seal for Pace Edwards Retractable Tonneau Covers #PE99CV does not come with great instructions. In order to install the Replacement Tailgate Top Seal for Pace Edwards Retractable Tonneau Covers #PE99CV, you will need to…