Custom Fit 2014 Ford F-150 Accessories

With there already being a factory hitch installed on your 2010 Ford F-150, we do have an option to up the tongue weight capacity. That being said, there are no Class V hitches that we have available for your vehicle, so this will be a Class IV hitch…

There are two ways to add a hitch to your 2013 Ford F-150 that already has a factory hitch installed. The first is to add the TorkLift #TLF1005H. This is only designed for short bed models and trucks with a factory hitch rated for 10,500 lbs. It also…

Though The Curt Double Lock, Flip and Store Underbed Gooseneck Hitch #C60721 is not confirmed to fit your 2013 Ford F-150, The B&W Turnoverball Underbed Gooseneck Trailer Hitch w/ Custom Installation Kit #BWGNRK1104 is confirmed to fit. The…

The B&W Turnoverball Underbed Gooseneck Trailer Hitch w/ Custom Installation Kit - 30,000 lbs #BWGNRK1104 is a confirmed fit for your 2004 Ford F-150. With the 5-1/2 foot bed, I do recommend using the 4" Offset Ball for B&W Turnoverball…

The B&W Turnoverball System #BWGNRK1104 is a confirmed fit for your 2011 Ford F-150. The B&W Turnoverball Underbed Gooseneck Trailer Hitch - 30,000 lbs #BWGNRC959 you're referencing is really just a replacement gooseneck section, but is…

Hello Scott, thanks for reaching out. The RV Propane Gas and Carbon Monoxide Detector #RS34FR can be used to replace your Safe-T-Alert 30-441-P detector but this is not a direct replacement. Basically, you will just want to be sure you have room for…

I had our warehouse measure the Timbren Rear Suspension Enhancement #TFR1504D you were looking at for your 2014 Ford F-150, and the overall height is right at 8-5/8". With that measurement in mind and your 9" clearance, you do not need to…

Brake controller wiring harness #22292 plugs into the built-in connector beneath your vehicle's dashboard. To access this connector, first locate the instrument cluster finish panel in the center of your dash, near the driver's side.…

Hello John, thanks for reaching out. We may have an option for you, but we do not carry the Ecotric brand. This appears to be a brand carried mainly only by the jungle website. It may be possible to use the Curt High-Rise Ball #C60603 as a…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

To start you will want the Kodiak Disc Brake kit part #KOD69FR which is a Dacromet coated hub and rotor kit that fits your spindle. You will need to swap out the grease seals though to the #GS-2125DL since you have the slightly smaller spindle. Then…

A replacement coupler option that is very similar to the existing coupler on your EZ Loader Trailer is the Dexter DX7.5L A-60, Drum, 2 Inch Ball Brake Actuator #DX33FR. Dexter acquired UFP, so actuator is essentially an updated version of your…