Custom Fit 2012 Honda Odyssey Accessories

Just to make sure we are accurate on the actual rise you may need, lets cover some basics. With the tow vehicle parked on level ground, measure from the ground to the top of your hitch receiver opening. Then, with the trailer level, measure from…

For your needs the Westslope part #RKY10223 would be the better option since it's a bit lighter weight which makes loading and unloading much easier. These racks do not slide out of the hitch tube as easily as you'd think. If you…

You will need to start with a 4-way (if you do not have one). For that you would want the #118521 for your 2012 Honda Odyssey. From there you would need to convert the 4-way to a 7-way so that you can install the brake controller. For that you will…

I looked up the instructions for the Draw-Tite hitch, part #75270, and the torque specification for the 6 M12 bolts is 68 Lb.-Ft. I have added a link to the instructions below so that you can review them. The torque rating is just above the small…

For the Draw-Tite trailer hitch, #75270, or any of the trailer hitches we carry, the torque specifications can be found after the last step in the installation instructions that are linked on the page. Because the design of a hitch could change or…

We don't post the torque specs for the hitches we carry as they are subject to change by the manufacturer and since we link the install instructions for all of the hitches directly from the manufacturer if they were to ever change our…

I attached a picture that shows the modification needed to the bumper beam bracket. Exhaust lowering is not needed to install the hitch either. You will need to use the washers like what is shown for the install of the #76025 on a 2016 Honda…

I attached a link to the install video for the Draw Tite hitch part #76025 as well as a link to the install instructions for you to check out as well.

The distance between the mounting holes of the Erickson wheel chock kit part #EM98CV from left to right on center are 4-1/2 inches.

The Draw Tite hitch part #76025 that you referenced is a confirmed fit for your 2012 Honda Odyssey. It would install exactly the same as the video that shows the hitch installed on a 2014 Honda Odyssey. I checked the install instructions and there…

Before we determine that you have the wrong size install bolts you need to make sure that the bolts not fitting isn't due to the weld nuts of your vehicle being dirty/corroded and that is why they won't fit. Typically on vehicles that…

I called my contact at Draw-Tite and asked about the installation of the #75270 on your odyssey. They told me that the instructions clearly show the spacers placed between the frame rail and the hitch and they recommend having the installation…