I do have an option for you but there isn't a spare tire holder designed to be used with the 24x60 etrailer Cargo Carrier for RV Bumper part #e99049. That said, you might be able to use something like the CE Smith Spare Tire Carrier for Trailers…
If by 'install kit' you're referring to a wiring adapter like the #3040-P you'd looked at, then yes you'll need a wiring adapter to install a brake controller on your 2010 Toyota Sequoia with the factory 7-way. If you haven't…
The Tekonsha Prodigy P3 Brake Controller, #90195, does not have an on and off switch. It will go into sleep mode after several minutes of no activity. The power draw when it is in the sleep mode is so negligible that it will not discharge the…
When choosing a weight distribution system, the most important factor to consider is the total tongue weight of your setup. This will include both the loaded tongue weight of your trailer, along with any added cargo weight coming from behind the rear…
Weight distribution works to distribute the tongue weight of a trailer up to the front axle of the tow vehicle so that it will sit more level and handle/brake better. That being said the systems do not "reduce" tongue weight or allow you to…
Brake controllers such as the P3 you referenced #90195 will go into a sleep mode after about 15 minutes of it sensing no movement. If you peek through the window after 15 minutes then it should be in sleep mode. Opening the door or causing movement…
Since your 2006 Toyota Sequoia came with a factory tow package, you can plug in the wiring harness, #3040-P into the port on the vehicle. It is located under the dash to the left of and above the the emergency brake. You will remove the panel that is…
I went out to the warehouse and pulled the Replacement Square-Bar Clamp-On for Thule Ride-On Adapter #853-2156 and found that it is 1-1/8" wide by 1" tall and the Thule Square Bar Adapter for Fairing #853-7362 is 1-7/16" wide by…
As of right now (May 2017) the only confirmed Air Helper Springs for your 2017 Toyota Sequoia are the Air Lift #AL60826 and #AL60786. There are no options from Timbren as of yet. Before investing in a suspension system what I recommend doing is…
Thank you for the photo and you definitely need some suspension help there on your 2008 Toyota Sequoia SR5 with the sag you have. Since you have the SR5, so long as your Sequoia does not have auto leveling, the air spring system you need is from Air…
The Air Lift kit part #AL60786 is for the SR-5 models of the 2011 Toyota Sequoia and the part #AL60826 is for the other models aside from the Platinum version. Since you do not have a SR-5 or Platinum the correct kit is the #AL60826.
After you've packed the bearings and assembled everything, carefully slide the hub assembly onto the spindle and install the outer bearing. Install the spindle and tang washer and run the spindle nut down finger tight, then rotate the hub back…
