I just went out to the warehouse and measured the Curt Trailer Hitch Receiver item #C15845. I have attached a couple of diagrams with the dimensions of this hitch on them. From the center of the back bolt to the front of the receiver is 26" The…
Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…
The numbers that you mentioned are actually for the races that pair with the inner and outer bearings in the trailer hub. The #L44610 race is commonly used with the #L68149 inner bearing while the #L68111 race is usually paired with the #L44649 outer…
After speaking to my contact at Curt, I have found the Curt Gooseneck Flat Plate #C65500 is a compatible fit for your 2002 Ford F-550 Super Duty without a bed. It comes with a 2-5/16 inch ball rated at 30,000 lbs and D rings. With the amount of…
Hi Mark; if you need a 16" x 6" rim with an 8 on 6-1/2 bolt pattern, 5.35" offset, and 4.77" pilot diameter then technically the #AM83NR will fit. However, all of our wheels are rated for trailer use so we do not recommend using…
For a 2005 Ford E-450 RV Cutaway chassis you'd want the Draw Tite hitch part #65001 which is a confirmed fit. I attached an install video for this for you to check out as well.
I went out to our warehouse to get these measurements for the Replacement Bottom Ladder Section #SU77VR. These have an overall length of 36" with the two 7/8" inserts spaced 11" on center. The 7/8" is the outer diameter of the…
You can have a 2-5/16 inch hitch ball on either a 1 inch or 1-1/4 inch shank. The nut on a hitch ball with a 1-1/4 inch shank takes a wrench with a 1-7/8 inch socket. A hitch ball with a 1 inch shank will take a wrench with a 1-1/2 inch socket. You…
Most of the 2-5/16 inch hitch balls will use either a 1-inch diameter shank or 1-1/4 inch diameter shank. The nut size on a hitch ball with a 1-1/4 inch shank, like the Tow Ready 2-5/16 Inch Hitch Ball, part #19286, will use a 1-7/8 inch socket. A…
I was able to go out to the warehouse and measure the diameter of the hole on the #WM9003-4 for the hubcap that these will snap into and got 1.327 or about 1-1/8 inches. I also measured the nut impression size and got 1.037 or about 1-1/32 inches.
Do you see the white plastic piece in the shape of a U in the picture that you sent me? You will need to pull that piece out away from the harness to release it from the rest of the 7-way. Check out the video I attached and skip to the 3:25 mark to…
The tubing on the aluminum uprights for the Stromberg Carlson RV Exterior Ladder #LA-401 that you referenced features an outer diameter of exactly 1 inch. I have attached a short video demonstration that you can also check out.
