Custom Fit 2007 Toyota Highlander Accessories

Yes, it does. The Curt T-Connector Vehicle Wiring Harness item #C47WR is confirmed to fit the 2023 Ford Bronco Sport. This custom fit T-connector plugs into your Bronco's existing wiring harness behind the tail lights. This harness will…

The etrailer J-Style Kayak Carrier part #e98878 will be a great solution! It has a really high capacity compared to the others at 150 lbs. It will also included everything that you need to tie it down. The straps for securing it to the rack, the…

If you have no power to the trailer wiring harness, the fuse panel is located in the engine compartment. I have attached a drawing that shows where the fuse panels are located on a 2006 Highlander. Per the second attached drawing the fuse for…

Thank you for the photo of your Coleman Fleetwood pop-up camper for which you want a storage cover. You'll get the best fit by carefully measuring the length, width and height of the camper. If you want a cover to also protect your propane…

The white wire on the back of the GloLight LED Trailer Tail Light part #STL178RB is for the ground. If you were wiring it to a trailer connector like part #HMC20031 then you would just need to make sure that it is attached to the ground terminal…

Yes, your 2007 Toyota Highlander (Non-Hybrid) will require a converter box because it has a separate wiring system in which the brake and turn signals are on different circuits. In order to combine them which will be needed for any trailers here in…

The only difference between the Curt Trailer Hitch Receiver part #13530 and the etrailer Trailer Hitch Receiver part #e98857 for a 2006 Toyota Highlander is finish. The Curt hitch has a shiny finish and the etrailer hitch has a matte finish which…

For your 2006 Toyota Highlander the Curt hitch part #13530 fits and unlike other options allows a full sized spare to be stored underneath it. I attached an install video for this hitch for you to check out as well.

Our 10 gauge wire is stranded, not solid core.

I'd recommend using 10 gauge wire like part #10-2-1 (sold by the foot) for the brake power and ground wires as this will be more than adequate and will ensure you get plenty of amperage to activate the brakes.

Yes, the etrailer.com Trailer Hitch Receiver #E98857 referenced in your question is confirmed to fit your Hybrid model of the 2007 Toyota Highlander. This custom Class III hitch will use existing holes in the vehicle's frame for a no-drill…

To determine if you could use the Tow Ready wiring harness part #118248 on your 2007 Toyota Highlander the most efficient way would be to determine if you have the trailer wiring connector on your vehicle, and then use a circuit tester like part…