Truck Bed Tents Specs:
Features:
...Split corners help the tent fit snugly between your truck bed and truck cab Added features make camping easier 2 Gear pockets for stashing your stuff 1 Hook for hanging lanterns or other equipment...
More Information >Truck Bed Tents Specs:
Features:
...Split corners help the tent fit snugly between your truck bed and truck cab Added features make camping easier 2 Gear pockets for stashing your stuff 1 Hook for hanging lanterns or other equipment...
More Information >Videos
for Truck Bed Tents
Help Articles
for Truck Bed Tents
Expert Answers
for Truck Bed Tents
The number you provided, "7753400" is a patent number which corelates to the Equalizer for E-Z Flex Suspension part #013-144-03. This is for a single equalizer but if you need the entire kit…
view full answer...The length of wire desired depends on your vehicle connection and your personal preference. You want enough slack for turning, but not so much for dragging as you mentioned. A little extra slack isn't a problem and not…
view full answer...For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…
view full answer...The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…
view full answer...On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…
view full answer...The modern size equivalent of the 20.5x8-10 that you have currently would be the same size tire that is on the #AM3H340 that you referenced, 205/65-10. As long as the bolt pattern of your current hubs are 4 on 4 inch the wheels of this would bolt…
view full answer...The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…
view full answer...The "radio" fuse of your 2014 Honda CR-V will need to be pulled and replaced with the Roadmaster FuseMaster Fuse Bypass part #RM76511. This product will make it easy to deactivate this circuit, you will only…
view full answer...I am not totally sure which wires you are talking about, but I am assuming it's part of the bonded wire that runs up to the engine compartment? If so, the white wire gets grounded as it's part of wiring up the…
view full answer...90-120 ft lbs of torque is probably about right for your trailer rims. If you check out the lug nut torque chart that I attached you will see that nearly all of the torque specs are that and higher.
view full answer...The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…
view full answer...Hey Gregg, The etrailer Hard Tonneau Cover #e23DR mounts to the inner lip of the bedrails with clamps so you'll need access to that lip in order to install it. If your bed liner is plastic you can just cut out holes where the…
view full answer...Filter Products (4)