Tow Bar Wiring Specs:
Features:
...Lets you wire your vehicle to accept your RV's tail, brake, and turn signal lights for flat towing Wires towed car as combined system so that brake and turn signals travel along ...
More Information >Tow Bar Wiring Specs:
Features:
...Carries your RV's tail, brake, and turn signals to your towed car Prevents feedback that can damage your vehicle's electrical components with diodes Includes: 4 Hy-Power d...
More Information >Tow Bar Wiring Specs:
Features:
...Complete wiring kit lets you connect your RV's tail, brake, and turn signal lights to your towed vehicle's lighting system Wires towed car as a combined lighting s...
More Information >Tow Bar Wiring Specs:
Features:
...Lets you wire your vehicle to accept your RV's tail, brake, and turn signal lights for flat towing Wires towed car as combined system so that brake and turn signals travel along ...
More Information >Videos
for Tow Bar Wiring
Help Articles
for Tow Bar Wiring
Expert Answers
for Tow Bar Wiring
If you are installing just the Firestone Ride-Rite kit, #F2400, and not also adding an on-board air compressor such as #F2158, then I would estimate that it should take about 2 hours to install the kit. That is for someone with some mechanical…
view full answer...I&…
view full answer...If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…
view full answer...Your trailer looks awesome! The Road armor equalizers #LC696740 and Equa-Flex Cushioned Equalizers #LC279687 are both pretty similar in performance even though the Road Armor has two dampers. The main difference is the size of the equalizers. The…
view full answer...If your old axles have a 5 bolt brake flange the assemblies like Dexter Electric Trailer Brake Assembly -…
view full answer...The Trailer Leaf Spring, 2250 lbs. 6 Leaf, item #e27SR, is sold as a replacement spring for older trailers and measures 26 inches for eye to eye, center to center. If you are replacing the springs and hangers you will need to use the same center to…
view full answer...Assuming your Sprinter has the factory tow package with the 7-way at the rear bumper, in addition to the #RED24FR Redarc Tow-Pro Liberty Brake Controller,…
view full answer...The best option we offer for your dump trailer is the Erickson Mesh Tarp and Truck Bed Cover part #EM57059 which measures…
view full answer...I would be happy to! To flat tow your 2024 GMC Canyon Denali you will need the following parts: Tow Bar and Safety Chains - Roadmaster Nighthawk All-Terrain Tow Bar w/ LED Lights item #RM-676 Base Plate Kit - Roadmaster Direct-Connect Base Plate…
view full answer...What you need for your Isuzu NPR truck is a powered converter #C59236. It is compatible with incandescent and LED trailer lights. I have included a link to the installation instructions for you. This harness does require a direct connection to the…
view full answer...The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…
view full answer...I would be happy to confirm the parts you referenced fit your 2019 Chevy Colorado and are compatible together. I have listed them below, along with any changes, and attached installation videos. Roadmaster Nighthawk All Terrain, Non-Binding Tow Bar…
view full answer...