Result: spacer block

For the 2016 model year Ford had both a Transit Connect and a Transit T250 but in either case there isn't a wiring harness to plug in a brake controller so one will have to be hardwired in. It is not all that difficult at all; just a lot of…

The easiest solution to add a brake controller to your 2020 Ford Transit T250 that has a 7-way installed already would be with the Curt Echo Mobile part #C51180 which basically just plugs into an active 7-way and once synced to a smart phone is ready…

The bolt sizes are commonly M12-1.25x40 and M10-1.25x35. If you are looking at the Draw-Tite Front Mount Trailer Hitch Receiver - Custom Fit - 2" #65075 the hardware comes with it and you can find the specs on the parts in the instruction manual…

If you can access an open end of the frame where the weld nut broke off you could fishwire a new carriage bolt in place of the weldnut. Otherwise you may have to weld the hitch on or see if a local garage like you mentioned could come up with a way…

Hey Matthew, the first thing you need to add a 7-way to your 2022 Honda Odyssey is a 4-way since there isn't a direct fitting 7-way available for your vehicle. So for a 4-way you would want the Tekonsha part #118781 which is very easy to install…

Yes, the carriage bolt blocks (they do look like spacers) and all install hardware are included with the Curt hitch part #13424. I attached a picture that shows all of the hardware that comes with the hitch. CM-SP6 is called out in the instructions…

While we don't have just the CM-SP12 spacers for the Curt Trailer Hitch Receiver #C13362, you can either get a complete replacement hardware kit with part #RHK or you can just get 2 of the Trailer Hitch Spacer Block - 3" Long x 1" Wide…

There are a few advantages and disadvantages when deciding between bias ply #AM3S334 and radial tires #AM31994. With radial tires, some advantages would be: 1. Improved comfort. 2. Superior heat management and heat dissipation. 3. Excellent tire…

Our trailer wheel and tires like the Kenda Karrier part #AM31990 that you mentioned do not come balanced. We do have balancing beads that you can use that will balance them for you like with the Counteract part #CA66VR which comes with enough to…

You should always follow what is printed on the side of the tire from the trailer tire manufacturer. Tires inevitably get replaced over time so what was printed on the trailer will no longer be accurate. For trailer tires, this will typically be the…

It would be odd for the 4-1/4 inch measurement to be accurate. I've attached an article on measuring bolt pattern for you to confirm your bolt pattern before ordering. If you do end up with the same measurements, you may want to consider changing…

With your loaded trailer weighing around 1,400 to 1,600 pounds, I would actually run the Kenda Karrier ST175/80R13 Radial Trailer Tire with 13" Galvanized Wheel - 5 on 4-1/2 - Load Range D #AM31994 at the 65 psi rating. This is due to the max…