Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Adding skid wheels to your open car trailer is indeed what I recommend to help prevent the trailer from dragging when going up a steep driveway. These are designed specifically for this very purpose and will work well. I recommend taking a look at…
view full answer...Yes, the H-Channel for Enclosed Trailer #36281-955 can be used for the side door frame on your enclosed trailer. It is specifically designed for building cabinets and doors on a trailer. There is also the 1/16" Thick Tube Trim for Enclosed…
view full answer...I confirmed with Diamond Group that the Hott Rod RV Water Heater Conversion Kit - Propane to Electric #DGR6VP needs a 15-amp circuit breaker. As far as the wiring for the Replacement Single-Panel On/Off Switch for Atwood Gas and Electric Water…
view full answer...I have attached for you the wiring part of the install instructions for the Camco Propane to Electricity Converter for 6-Gallon RV Water Heaters part #CAM11673 below.
view full answer...Hey Connor, To replace the O-Ring that comes with the Replacement Oil Cap Kit for AL-KO and Hayes 10,000-lb to 16,000-lb Axles #K71-859-00 you'll need the part #DX97CR which has a 3.487" inner diameter.
view full answer...The best way to find the correct replacement for your equalizer is by measuring the distance from the front shackle hole to rear shackle hole on your current equalizer. The 33" AllTrek #MR89DR has the holes spaced 6-1/2" on center while the…
view full answer...I have attached a link to all of our trailer hubs that use #L68149 and #L44649 bearings and have a 5 on 4-1/2 bolt pattern. I recommend the Dexter Trailer Hub Assembly #8-247-50UC3-EZ. This hub features a grease cap that is compatible with EZ lube…
view full answer...The Pollak #PK11998 wiring harness is the correct one that you would need. It plugs into the back of many different types of 7-Way trailer connectors so it isn't surprising that the one you have looks different than the ones we carry. As long as…
view full answer...The Pollak Connector PA66GF30 I believe is the same if not similar to the Pollak Replacement 7-Pole, RV-Style Trailer Connector Socket part #PK11893. If that is the case you can use the Mounting Bracket part #PK12711U and Curt No-Drill Bracket for…
view full answer...You are correct, the difference between the Electric Brake Assembly for 6K Axles, part #23-458 / 23-459 and the Electric Brake Assembly for 7K axles, part #23-180 / #23-181, is that the 7K brake assembly has a stronger magnet, and also has a…
view full answer...If your trailer's axles have the 5 bolt brake flange and 12 by 2 inch drums then the brake assemblies, part #AKEBRK-7-SA, will work for you. Verify by measuring the inner diameter and width of the drums. You should know that mobile home axles are…
view full answer...You are correct in your description of how to wire in a new auxiliary battery in your enclosed trailer. You will take the 7-Way's 12V power feed and route this to the positive terminal on the auxiliary battery, and you will ground the second…
view full answer...Filter Your Search
Contact and Help