Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Hey Chris, yes the part #MC62YR does have the 50.336 motor like you are looking for.
view full answer...Hello Jonathan, Thanks so much for reaching out. Since you already have a 160 watt roof panel and Odyssey TPPL batteries, adding another panel and updating your charging equipment is a great idea. For the solar side, I recommend the Go Power…
view full answer...Hey Robert, The Go Power Solar Charge Controller #GP32QR doesn't have a hand held remote, but it does have a touch screen mount #GP64XR that will allow you to control it. Which comes with Bluetooth capability so you would be able to control it…
view full answer...I'm happy to help with that isolator and wiring. I checked your invoice and see you went with the Battery Isolation Solenoid #PK5231201. This is a good choice and will need to be mounted to the frame because it uses the mounting holes for ground.…
view full answer...To replace your Kaper 1T-L6R taillights you are going to want to use the Custer Trailer Tail Light - Submersible - Stop, Turn, Tail - Incandescent - Oval - Red Lens item #G65R. These lights are 6-1/2" long x 2-5/16" tall x 2-1/2"…
view full answer...The Torklift Battery Mounting Box part #TLA7708R or #TLA7700L that you referenced can mount to the brackets you have on your trailer as there are several holes on the bottom of the box that you can use to run bolts through to then attach to your…
view full answer...The Redarc Smart Start Battery Isolator part #331-SBI212 will work great for your application as long as you have your 3 100 Amp deep cycle batteries wired in parallel and it is 12 volts. If your batteries are wired in series and output 36 volts it…
view full answer...The 5th wire on a 5-Way flat connector is intended to connect to the vehicle's reverse light circuit. This is for the exact situation you described, so the 5th wire can signal a surge coupler's electric reverse lockout. If you need a 5-Way…
view full answer...It could be a tow package fuse on the vehicle. Use the owners manual to find the locations of fuses/relays related to the tow package wiring to check them and replace as needed. If the issue is not a fuse or relay then you can test the vehicle side…
view full answer...You can use the RV Propane Gas Detector #RS64FR (white) or #RS44FR (black) to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.
view full answer...A lot of the older Atwood water heaters have been discontinued, yes. For your replacement I recommend the Atwood RV Water Heater #AT94022 which is a 10 gallon gas/electric unit like you currently have with an automatic pilot. This uses 120V power and…
view full answer...Yes. If you don't need the weight distribution bars attached to carry the trailer to storage, you can absolutely use just the WD hitch head and ball to tow the trailer. It will work just like a ball mount.
view full answer...