Search: Angle Iron Spare Tire Mount   >   !Bumper   >   Trailer Cargo Organizers   >  

We actually have a spare wheel carrier for trailers with angle-iron rails with the etrailer Spare Tire Carrier for Trailer with Angle-Iron Railing #e99045.

When wiring a 7-Way on your trailer with 5 wires, your green wire will be right turn/brake, the yellow wire will be left turn/brake, the brown wire will be the taillights, and the white wire will be the ground. You will want to find out if the blue…

Your trailer must have free backing brakes if you have never used the surge brake actuating coupler reverse lockout. If you did not have free backing brakes, your brakes would most likely brake even if they didn't lock up when you back up because…

Did you have a 4-pin connector that had 5 wires or was it a 5-pin connector? There is a big difference since you normally see a 5-pin connector on a boat trailer with the 5th pin used for an electric reverse lockout solenoid on a brake actuating…

The Demco Hydraulic Trailer Brake Actuator part #DM72VR should be a direct replacement for the Atwood 61101 Brake Actuator that you have now. This newest updated it rated at 7K instead of 6K. This is a bolt on option that mounts on 3" centers.…

For a replacement wheel stud for your Dexter hub part #84546UC3-EZ we have the part #7-122 which is the correct replacement.

On the Dexter Trailer Hub & Drum Assembly, part #8-174-5UC3, the wheel studs are a screw-in stud. The wheel stud would be the Trailer Hub Wheel Stud, part #25-11. This is a 9/16 inch stud that has a total length of 3 inches.

Yes, the Demco #40716-15 Hydraulic Brake Kit will fit your needs for a 10" X 2.5" assembly. When measuring the drum use inside measuerments as shown in the attached photo. You will just want to confirm your flange bolt pattern is 4 on…

The Kodiak Dacromet Disc Brake Conversion Kit, item #K2HR35D, would be a good choice for conversion to disc brakes on your boat trailer. We have not had the opportunity to do a video installation for the disc brake conversion yet, but I will go…

The recommended lug nut torque for your 7,000lb axle depends on a few factors like wheel size, stud size etc. Check out the attached photo which shows the torque specs for a variety of applications. I see you were looking at the Dexter Nev-R-Adjust…

I'd be happy to assist with that. In addition to the #HA81725 Hayes Synchroinizer brake controller, you'll need a universal wiring harness, part #HA81789-HBC and our Brake Controller Installation Kit, part #ETBC7. The kit includes everything…

The Fulton Economy Spare Tire Carrier with Wheel Nut Lock #FETCSTL0701 that you referenced would work just fine on a section of angle iron that is 2 inches by 2 inches. The frame does not have to completely fill out the U-bolt to allow the carrier to…