Search: 7 Wire Pigtail   >   !RV Bathroom   >   ATV-UTV Tie Downs   >  

While we don't carry that exact part number we do have a replacement hub/drum that would work just as well with the part #AKHD-655-6-EZ-K. This is a 6k hub/drum that fits the spindles of the Timbren Axle Less Kit part #ASR1THDS03.

We do carry the 33" Ark Stabilizer Jack that you are looking for with part #ARK77FR. I was able to track down a few drawings that you should find helpful. These are for the 30" #ARK94FR and the 24" #ARK34FR Stabilizer…

The length of wire desired depends on your vehicle connection and your personal preference. You want enough slack for turning, but not so much for dragging as you mentioned. A little extra slack isn't a problem and not enough could lead to…

On this page (typically below the product links) there is a helpful link section that will have the install instructions fo the Hopkins Breakaway kit part #20400 that you referenced. I also attached an install video that shows the kit installed as…

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

I contacted the manufacturer about the lengths for these stabilizer jacks and have included the information they were able to provide me. The Ark Drop Down Corner RV Stabilizer Jacks #ARK34FR are 422 mm (16.6") collapsed and 600mm (23.6")…

To flat tow your Ram 2500, you'll need a tow bar, base plates, safety cables, a wiring solution, a supplemental braking system and possibly a high/low adapter. I really like the equipment offered by Roadmaster, the quality and ease of use are…

It sounds like you are missing a wire for the running lights on your trailer. Trailers that are wired for lights will have 4 or 5 wires, one for right stop/turn, one for left stop/turn, one for ground and one, possibly two, for running lights. Does…

The Dexter Nev-R-Adjust electric trailer brakes can be manually adjusted. There are a couple teeth of the adjustment wheel that are exposed just under the lever that you referenced. I have attached a photo showing the teeth. You will likely need a…

The break away system on a trailer would typically have its own battery, like that shown with part #20400. The reason that pulling your break away switch does not actuate your brakes is that it is not wired correctly. The break away switch should be…

The black wire from the break away switch will connect to the blue wire from the break away box, as shown in the provided diagram. By 'brake wires' I'm assuming you're speaking of the wires connected to the brake magnets on your brake…

It sounds like either your brake controller is on a higher braking setting (most likely) or your brakes themselves might need some adjusting. If you need to adjust your brakes, you can use a tool like a Brake Adjustment Spoon, Item #W80630, or a flat…