Recommended Cover for 17' Boston Whaler Katama Boat
Hi! Im looking for a generic cover for my boat, its a 17 boston whaler Katama with a bow rail. I keep it under a car port, and I dont need to trailer it, I just want to kepp dust and animals out. do you all have any suggestions as to what a...
Can the Taylor Made Low Profile Fasteners for Removable Boat Windshields Be Bent?
I notice that the support rods have a slight bend where it attaches to the windshield p/n 3691607...My windshield requires a straight rod....can they be bent straight? and what are the dimensions of the same rods? | I am sure with enough force...
Will The Taylor Made Fender Adjusters # 3691139 Fit a Avalon LSZ Pontoon Boat?
Would these work on an Avalon LSZ pontoon boat rail where the sheeting is on the outside of the rail? | Unfortunately Christopher, I have no way to know what size rails are on your Avalon LSZ pontoon boat. The Taylor Made Fender Adjusters #...
Stroke Length of Taylor Made Marine Gas Strut 3691871-60
Can you please tell me the stroke length for this gas shock ? Taylor Made 1871-60** Thanks | I reached out to the manufacturer, Taylor Made, who was able to tell me the stroke length of the Taylor Made Marine Gas Strut for Boat Hatches # 3691871-60. They...
How Wide/Thick is the Taylor Made Roll-In Dock Wheel
What is the measurement thru the hub? Need to know how much axle is needed to mount this wheel. Thz | I spoke with Taylor Made about the Taylor Made Roll-In Dock Wheel part # 3691224 and they informed me that the wheel is 7-3/4" thick. Therefore,...
Boat Fender Recommendation for Scarab 255 with Cleats and No Railing
Need to hang on cleats Scarab 255No railing. | (See follow up question for solution below) I wish we had something, but if you don't have any railing or cleats at all on your Scarab we don't have a way to hang fenders. There are solutions elsewhere...
Does Taylor Made PWC Bumper Fit Kawasaki Jetski Ultra 310 SE
Will these fit a Kawasaki Jetski Ultra 310 SE? | Yes, the Taylor Made Personal Watercraft Fender # 3691069 does fit your Kawasaki Jetski Ultra 310 SE. |
Do the Gas Shocks Come With Mounting Hardware Included
Does the strut come with mounting brackets and ball or do you have to buy those separate? | A gas strut like the Gas Shock - 80 lb Force - 20" Extended, 11.41" Compressed - Black Nitride # 372-2300-80 is designed to replace an existing strut...
Recommended 23" Long Gas Strut fo a Camper Door
I am looking for a 23inch gas strut but I only need 10 lb of force. All it does is hold my camper door open as needed, and keep it from striking the arm of my awning. So there is no weight bearing involved. I could possibly use a 22 or 24 inch...
Are There Any Rubber Attachments For The Lippert Solid Step Fold Down Steps?
Foot Pad for Lippert SolidStep Manual Fold-Down Steps Is there a rubber attachments for the feet. | While Lippert does not manufacture rubber attachments for the Foot Pad # LC6451138, we do have the Bumpers # 3691167 you might consider. These...
Will the Taylor Made BoatGuard Eclipse V-Hull Bay Boat Cover Fit a 22' Boat with a 96" Beam
Will this fit a 22 foot V-hull boat with a 96 inch beam and still be trailable? I have a 2017 Glastron GT205 with with a swim platform that is 8 inches longer then the standard swim platform and the standard boat cover for this boat is too...
Diameter of Taylor Made Replacement Support Bar for Boat Windshields
Hi, I’ve a bayliner 05, 245 cruiser and looking to replace both support bars on my windshield. I Ordered the Taylor Made 12”, however the width is much smaller than my part. Can you tell me the width of the one you carry? Does It all come...
Shock/Lid Lifter Actuator for Hatch that Weighs 100 lbs
i,m building atear camper the back hatch is 7 feet 6 inch wide and 5 feet 6 inch high on the back radices and weights about 100 or so pounds what size shocks do i need? | Since the hatch weighs about 100 lbs a 90 lb force strut kit like the...
Can the Taylor Made Dock Wheel Bumper Be Mounted On Bottom of Dock
The water level at our lake is low right now and the hull of my boat is below the dock. Would it work if I installed a dock wheel on top and one on the bottom? | I reached out to Taylor made and although you can mount the Taylor Made Dock Wheel...
Are The Taylor Made Snap Fasteners Made From Stainless Steel?
Are these snap fasteners stainless steel? | The Taylor Made Snap Fasteners Male Ends # 369403 and Female Ends # 369401 are both made of stainless steel. You will need the Taylor Made Snap Fastener Installation Tool # 3691360 to install both...
Recommended Windshield Snap For A Boat Windshield With 3/4" Trim
Hello What size snap clip do I need on my boat windshield per the attached photo? | The windshield snap is going to go over the lower trim piece and clip into the gasket on the glass so based on the picture you've provided you'll need the Taylor...
Where to Measure to Pick Out Replacement Gas Strut Like 3691823
were do you measure from | You'd need to look at the two strut mounts you have and then measure the distance between them when the latch or hatch is in the open position and that's correct length you'd need. The part # 3691823 is 10 inches in...
Replacement Door Strut for Cargo Area Door and Entry Screen Door Closer
I need to know what door shock I need for my 2017 Keystone Cougar 326RDS door! I don’t have the old one it was gone when I bought it | If you are looking for a cargo door strut like # 3691832 we have many options based on length and strength....
How To Anchor the Taylor Made Sur-Mark Regulatory Marker Buoy
Im interested in some buoys to mark a dangerous reef. I like the look of your buoy 36946104. But if I get the permit to do this I dont know how to properly amchur the buoy. How many lbs of chain can the buoy handle before it to much? | I don't...
Will The Taylor Made Dock Pro Heavy Duty Bumper Mount To A 4x4 Post
I see that these measure 5 inches wide . Is it possible to use this on a 4x4 post . I dont mind if it goes past post , just want to make sure I am able to fasten to 4x4 | The Taylor Made Dock Pro Heavy Duty Dock Bumper - Edge Mount - 35-1/2"...
What Does Blue Stripe of Taylor Made Sur-Moor T3C Mooring Buoy with Center Tube
Weight buoyancy Says 240 lb is that from blue center stripe ? | The blue stripe of the Taylor Made Sur-Moor T3C Mooring Buoy with Center Tube # 36946374 is to indicate that it is an anchor buoy and does not indicate a load of any type. You'd...
Distance Between Mounting Holes of Taylor Made Bimini Top Eye Straps # 3691225
Can you tell me the length from the hole center to other center? | The distance between mounting hole centers of the Taylor Made Bimini Top Eye Straps # 3691225 is 1 inch. |
What Size Rope Comes w/ the Taylor Made Double-Eye Boat Fenders?
Please tell me the size diameter of the rope that is included | The rope that comes with the Taylor Made Double-Eye Boat Fenders item # 36931016B2P is 3/8" in diameter. |
How To Extended A Gas Strut That Is Stuck Closed
How do I release the new gas strut. It doesn’t extend. | I went out to our warehouse to see if all of our Taylor Made Marine Gas Strut for Boat Hatches # 3691837 were compressed like you mention yours is, and they are not. My thoughts are you...
Filter Your Search
Contact and Help