Will The Taylor Made Dock Pro Heavy Duty Bumper Mount To A 4x4 Post
Published 11/19/2021
Question:
I see that these measure 5 inches wide . Is it possible to use this on a 4x4 post . I dont mind if it goes past post , just want to make sure I am able to fasten to 4x4
asked by: Mark S
Expert Reply:
The Taylor Made Dock Pro Heavy Duty Dock Bumper - Edge Mount - 35-1/2" Long - White Vinyl # 36945500 does measure 5" wide with the mounting holes being approximately 1/2" from the edge. There is a rounded divot from the 1" mark to the 4" mark so if mounting this vertically I would also use some sort of rope or a large zip tie to prevent the wind from catching the portion that overhangs your 4x4 post and pulling on the screws.
Product Page this Question was Asked From
Taylor Made Dock Pro Heavy Duty Dock or Post Bumper - 35-1/2" Long - White Vinyl
- Boat Dock Bumpers
- Dock Bumpers
- Straight Bumper
- Vinyl
- 0 - 5 Inch Wide
- 3 - 5 Feet Long
- White
- Taylor Made
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Recommendations On Dock Bumpers For A Wahoo Aluminum Boat Dock
- Q&A: Dimensions of etrailer Single Axle Trailer Fender w/ Side Steps # HP93RR
- Article: How to Install an RV Awning From Scratch
- Q&A: Replacement Parts and Winch for a Profile 2000 Hand Winch
- Q&A: Taylor Made Dock Pro Dock Bumper Length
- Q&A: How to Install Yates Keel Pad on Crossmember
- Q&A: What Size and Type of Hardware is Needed to Install the Jif Marine Dock Bumper
- Q&A: Availability of Hitch for 2010 Hyundai Elantra Touring