Result:

Which Kat's Block Heater Fits 2025 Mitsubishi Outlander SE 2.5 Liter

Will this heater work, without modification, on my 2025 Mitsubishi Outlander SE? Please confirm the location for this vehicle as well. | Hey James, yes the Kat's Heater part # KH11812 that you referenced is a confirmed fit for your 2025 Mitsubishi...

Is There Rhino Rack Roof Rack that Fits 2015 Buick Regal

This apply as well to a 2015 Buick Regal? | Hey Pedro, we have a Rhino Rack roof rack that fits your 2015 Buick Regal with the part # RR98PP. This is a complete kit and will give you an aero bar roof rack that is confirmed as a fit for your...

Why Choose a Powered Taillight Converter Over a Non-Powered Model

What dictates the need between using a powered Tail light convertor Vs a non powered? | There's a couple of factors that determine that. On older vehicles, very few vehicles needed a powered converter, because the vehicle's electrical system...

Scooter Carrier for Rear of Motorhome With Rear-Mounted Spare Tire

What carrier will fit | The extended overhang at the rear of a motorhome means that any hitch mounted accessory installed in the hitch will be subjected to more jarring and bouncing than it would if it were instealled in a hitch on a standard...

Replacement Jack For 2001 Stratos Bass Boat Trailer

I have a 2001 Stratos Bass boat with a Fulton center bolt swivel jack onto a welded plate on the trailer. I would like to upgrade to the Fulton F2. My holes on the plate are 3X3 on center. Will the F2 work? Can I send you picture? Thank You...

Does The GE Appliances RV Refrigerator GE58FR Come With A Mounting Bracket?

Does this with mounting brackets? | Hello Raymond, thanks for reaching out. The mounting brackets are not included with the GE Appliances RV Refrigerator # GE58FR. It requires a GE approved top bracket part BMT-GPV10. This is not something we...

How to Measure Ball Mount Rise for Draw-Tite Sportframe Ball Mount # 3594 on a 2002 Buick Regal

how do i determine ball mount rise | Ball mount rise, or drop, is determined by inserting the ball mount into the hitch on your vehicle and measuring from the top of the hitch opening to the top of the ball mount platform. I added a photo showing...

Why is a Stabilizing Strap Recommended on Curt Hitches and what is Meant by Non-Trailer Load

What is meant by stabilizing straps for non-trailer loads? | Non-trailer loads are hitch accessories like bike racks and cargo carriers. Basically anything that is not a trailer that you could put on a hitch. Curt recommends you use a Curt Trailer...

Installation Instructions for Wiring a 2008 Volkswagen Rabbit to Tow a Trailer

My question is about the electical hook-up. Can I splice a 4-flat connector directly into the wiring harness, or do I need some kind of powered module dure to the fact that it6 haqs LED lights? | Due to the MX (Multi-Plexed) wiring system on...

What is the Battery Life for Hopkins Wireless Magnetic Tow Lights

What is range of battery life for these lights? The check battery level indicator light every 2 hours statement has me concerned. I drive for much longer stretches than that and dont wish to carry excessive spare AAs or replace them every couple...

How to Prevent Exhaust Components from Contacting the Trailer Hitch

I purchased the replacement CURT trailer hitch hardware from eTrailer for this hitch and installed the 11074 on my 2009 4DR Rabbit. However - after install, I now experience a lot more noise at low RPMs. Theres vibration being transmitted back...

Replacement Curt Trailer Hitch Hardware Kit for a 2009 Volkswagen Rabbit

Hi - I recently received a CURT C11074 Trailer hitch for the 2009 VW Rabbit from a friend who no longer has their MK5 rabbit. Is it possible to purchase *only* the replacement mounting hardware for this specific mount instead of the generic...

Is Trimming of the Foam Absorber Required for the Curt Hitch On a 2010 Mini Cooper Convertible

have a question about hitch and hard form . I removed the bumper today for preparation for hitch installation. The bumper has the hard foam but it is wedge between the front and back metal bumper with a full metal back hard foam cannot be...

Recommendation For Flat Towing A 2011 Buick Regal 2.4L

I have a 2011 Buick Regal 2.4L. A friend has done business with etrailer in the past and said your the best. Can you provide a quote for everything you would recommend I use for a complete installation. The car has never been used as a dingy...

Brake Controller Installation on 2014 Hyundai Santa Fe

Does wiring comes with vehicule for a electric brake?On a. 2014 Hyundai Santa Fe | If you're wanting to tow a trailer equipped with electric brakes using your 2014 Hyundai Santa Fe (and that's what it sounds like), you'll first need to install...

Exhaust Rattling Against Trailer Hitch on a Honda Pilot

Hi,I have recently bought a Curt receiver 13328. The installation went smooth but the hitch is touching the exhaust pipes. When I drive it makes a vibration noise. How do I fix this. | Exhaust rattling against a trailer hitch is a common occurrence...