Result: part

You will need to start with a 4-way on your 1991 Chevy 1500. For that you would want the #18252. From there you would need to convert the 4-way to a 7-way so that you can install the brake controller. For that you will want the Brake Controller…

To install the Draw-Tite 4-Pole Hardwire Kit Including Circuit Tester, part #18252, on your 2008 Ford F-150 you will need to access the wiring harness behind each tail light assembly, starting at the drivers side. Activate the left turn signal, and…

For your 2013 Dodge Grand Caravan with Stow-N-Go I recommend the Draw-Tite Max-Frame Trailer Hitch Receiver part #75579 which is a confirmed fit that installs using pre drilled holes in the frame. This hitch has a class III rating with a 2"…

You are correct that disc brakes require an actuator with higher psi pressure than what is required by drum brakes. Drum brakes need pressure of 1000-psi but discs need 1500 to 1600-psi. You can convert your Titan Surge-O-Matic Model 6 actuator to…

The install for the two kits you mentioned part #AL60818HD and #AL60818 is the exact same. The only difference between the two kits is the capacity of the bags. The HD kit has a capacity of up to 2,100 lbs and the other up to 1,000 lbs. The install…

I forwarded this to our contact at Demco and what they responded with is below. The short answer is you should already have all of the parts you need: The baseplate for the 2018 Chevy Equinox ( #DM9519332) is the Demco tabless baseplate. The 2015…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

Assuming you are in that 9-10" range you can use the Draw-Tite Ball Mount #80248. This has a 9-3/4" rise and a gross towing weight of 3,500 lbs which would be perfect for your trailer. You will also need #C40002 for a 1-7/8" ball or…

I've attached a diagram for you with function locations. Your left turn and stop are what will need to be connected for the flashers to work. These are found on the left and right side blades of your 7-way connectors. I recommend using a circuit…

The correct replacement upper strap for your Yakima KingJoe Pro 2, model 8002624, is part #Y37FR. Just in case, here's a list of other replacements parts compatible with your bike rack: Replacement Lower Side Strap #8880220 Replacement Strap…

It looks like from the photos I was able to find, the 2003 Coachmen Clipper Sport 106 will take a standard A-frame trailer jack. For that reason you can use something like the Buyers Products A-Frame Jack w/ Support Foot - 15" Travel - 2,000 lbs…

The Curt hitch part #14055 will fit the cutaway models of the 2003 Ford E-350 if the bolt holes on the frame of the van are 38-1/4 inches apart on center. I attached an install video for you to check out as well.