Result: master lock

The key you have now that has CF343 is the same as our part #GL93FR.

In regards to the B&W Extend-A-Goose Gooseneck Coupler part #BWTEXA4200, the distance from the bend in the upright to the bottom of the coupler is right at 9". I went out to our warehouse to measure this for you and created a diagram as…

Hey Steven, I did head out to our warehouse and confirm the dimensions of the Bauer #BA28UR are as stated 5-1/4" tall x 4-1/2" wide. I did however locate one that is the size you need and the lock we recommend for replacing the BP12 that…

Thank you for the pictures of the door latch on your Exiss horse trailer. Based on that the correct replacement is the Bauer #BA64FR that you referenced.

I spoke with my contact at B and W and they informed me that when the B&W Extend-A-Goose Gooseneck Coupler #BWTEXA4200 is in the lowest position it has a height of 11-3/4 inches.

The only difference between 7-Way Utility and 7-Way RV is the color of the wires. The pin outs are the exact same so either would work just fine with the other. If you check out the picture I attached you'll see that the functions are all the…

The part #RG04-020 might be barely too tight of a fit. Instead you would want the part #F001610 which is designed for fitting 1.96 bores on hubs like what you have. The overall height of this is 1.375 inches.

Hey Greg! Where did your Stromberg Carlson Base Pad Extreme #SC53VR crack? The Andersen Trailer Jack Block #AN39VR is a good alternative. It has the same 6,000 lb capacity and the design is a little more basic/straightforward which makes it less…

I do have some advice for you but CE Smith does not provide any torque values for the CE Smith Boat Trailer part #CE48810 save for the lug nuts as you mentioned. The torque sequence as laid out in the attached instructions will be far more important…

The correct bearing kit for a Dexter 4,400 lbs axle is item #BK2-100. The Dexter 4,400 lbs axles use the same bearings and seals as a Lippert 3,500 lbs axles. This kit includes inner bearing item #L68149, inner race item #L68111, outer bearing item…

Unfortunately, Michael I cannot find any information on an AL-KO 7170 trailer hub. I would need for you to see what size bearings your hub uses and send me some images along with dimensions to identify the bolt pattern and any side brakes it may use…

The correct replacement we offer for an AL-KO 568182 or Hayes 09089324 is the Trailer Hub and Drum Assembly part #AKHD-865-7-1-EZ-K which will work with the EZ-Lube Spindles (Dexter) and UltraLube (AL-KO). I can confirm the above will fit an AL-KO…