Result: 30 amp plug

Since my batteries are getting old, I was advised to plug my 50 amp motorhome into an available 110 receptacle while in storage. This part you offer appears to fit the bill. Is it ok to use just the 110 part of the plug? I plan to use both...

Im looking at putting solar and a 30 amp shore power plug on my enclosed trailer just when it comes to 12v and 110 trying to get everything to work together is where I get confused this looks like my best option I will be running a small portable...

Regarding Epicord RV Power Cord with Handle - 50 Amp Male Plug - 36 Long Pigtail. What is the thickness of cord | The thickness of the Epicord RV Power Cord with Handle - 50 Amp Male Plug part # 277-000154 is 1". In the cord there are 3-6 gauge...

I already have the Hopkins 47185 etrailer 37185 adapter on my 2001 Jeep Cherokee. Im going to install a Prodigy P2 Brake Controller one axle trailer. Your ETBC7 kit includes the 37185 plus all the circuit breakers , hardware, etc. I dont need...

Is it 10 or 12 gauge wire. 30 amp circuit should probably be 10 gauge. | The wire that comes with the 7-Way RV Upgrade Kit for Trailer Brake Controller Installation # ETBC7L for the power circuit for the Echo # C51180 is 12 gauge. I would agree...

I have a 2014 Jeep Cherokee with a toeing kit. I like the Tekonsha 90885. Is this a good choice? Do I need any thing else to connect it? | Great choice for a brake controller if you have electric brakes on your trailer. The Tekonsha P2 Brake...

Can you give me some ideas as to which brake controller and necessary wiring and connectors I will need to set up my 1996 Jeep Cherokee for hauling a 2-horse trailer maximum trailer weight of 5000 pounds? | Since your 1996 Jeep Cherokee did...

I have a 1991 Jeep Cherokee Sport, recently purchased a tent trailer with a 7 blade connector which is connected to the lights, as well as a 12 volt battery for charging purposes. The Jeep already has a 4 pin connector wired to it, but I am...

I have a travel trailer that I’m looking to upgrade the power system of. It currently has a WFCO 8735 distribution panel with an integrated converter that cannot be upgraded for Lithium batteries, so I’m planning to replace the whole unit. I...

What is the current draw for the jack? I need to know this value to determine the wire gauge. What is the lift rate/time? I have a 7000 lb capacity flat bed trailer. The empty tongue weight is 350# with a max tongue weight of 800#. |...

I have a 2015 Jeep Cherokee Limited 6 cylinder which I purchased without the tow package. I took it back to the dealer and had them install a Jeep hitch and wiring, and Im seeing both a 4 pin and a 7 pin connector. My question is, what do I...

I have a 2021 Jeep Cherokee Latitude Lux 4x4 with a factory installed tow package. I just installed the Curt TriFlex Next Trailer Brake Controller with the harness that matched my vehicle. My question, is there a fuse that needs to replaced...

My recent purchase of a 7-way trailer plug, for installation on a 2001 Jeep Cherokee XJ, includes plugging the blue wire into an existing factory installed blue wire. Where can I find this factory installed blue wire in the rear of my vehicle...

I have a 2015 cherokee latitude with no factory tow package. Some people say that the wiring harness is still installed and some say not. I am not sure what wiring harness to buy. Is my jeep wired for trailer hookup? Thanks | Since your 2015...

Can a flat four pin plug work with this brake controller if we use an adapter that switches the vehicles flat 4 pin into a 7 pin plug. Knowing that only the running lights, brake, and turn signals will be working out of the 7 pin adapter. Assuming...

what is the fuse number on a jeep Cherokee for factory tow package | If so equipped, the collective of circuits that make up the tow package is protected by 6 different fuses that protect the various circuits. The fuses are located in the...

I purchased a 2015 jeep trail hawk with the Road Master Falcon installed. It has the insta brake system. My motorhome has a 4 pin connector what is needed to make brakes operational ? Thanks | What you'll need to do is add a 7-way to your...

hi: Part for battery disconnect or wiring for same function | According to Roadmaster the 2021 Jeep Cherokee will require a Roadmaster # RM-156-25 Battery Charge Line Kit that will add a cable from the 6-way connector to your Jeep's battery....

I had the harness kit installed in my Jeep so I could flat tow the vehicle behind my RV. On my first trip, I plugged in my brake system into the cigarette lighter of the jeep. When we got to our destination, the battery was drained. Since...

I have a 2021 Jeep Cherokee Trail Hawk set up for flat towing, what do I need to keep the battery from going dead when I am towing? I am tierd of stopping and letting the engine run for awhile every several hours. | We have what you are looking...

My trailer has a 6 way round connection which plugs directly into my 6 way round trailer light connection on my 1995 Jeep Cherokee. A friend wants to use my trailer on his vehicle which has a 4 pin trailer light connection. Is there an adapter...

Installed on a 2015 Jeep Cherokee. When I plug in the trailer harness the included 15amp fuse blows. What could be causing this? | The Tekonsha T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector # 118605 having the included fuse...

No power to the Prodigy P3 brake controller on Ford E350 2003 RV. Used your universal kit to put 7-pin in had existing 4 pin. Ran wires. Black via 40 amp fuse to positive battery. White to blue wire on 3035-p adapter. The weird thing is that...

How does the charging cable hook up to the motor home and to the tow vehicle. What else do I need besides the kit. | It sounds like you are referring to the Roadmaster Battery Charge Line Kit # RM-156-25 for your 2018 Jeep Cherokee. This kit...