Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
There are a couple of things to take a look at with the Progressive Dynamics Inteli-Power RV Converter and Battery Charger #PD9130 & Charge Wizard #PD92201. The most likely is either a blown fuse (or fuses) so you will want to start there.…
view full answer...Yes, for a white base version of the #RVPL7CB you'd want the part #RVPL7C.
view full answer...The first thing I would want to know here is where you tested the voltage at on the Charge Wizard #PD92201 - if you didn't test it directly at the converter box, you'll want to start there. If the voltage at the converter is different…
view full answer...The lens you are looking for is part #APL5CB which is the clear lens for the RV Porch and Utility Light #RVPL7CB.
view full answer...The fuses for the 7-way trailer connector on your 2013 Ford F-150 are in the power distribution center as follows: Trailer Tow Brake Control #17 30 Amp Fuse Trailer Tow Battery Charge #21 20 Amp Fuse Trailer Tow Back-Up Lamp #43 15 Amp Fuse Trailer…
view full answer...Blue Ox has an easy system for determining the weight capacity of your spring bars, whereas other companies may use measurements or printed capacity to assist. With Blue Ox, there is a 5 dimple system: No dimples means it is rated for up to 350 lbs…
view full answer...The controller would need to be hardwired to your C5500 motorhome as it would not have a harness under the dash using our Brake Controller Installation Kit, part #ETBC7. Due to the fact that your motorhome is longer than the usual passenger vehicle,…
view full answer...There are not many differences between a welded and forged weight distribution shank in regards to practicality. They both pass the same DOT standards and meet the maximum 15,000 lb weight capacity requirement. The forged shanks started to become…
view full answer...The 4-Leaf Double-Eye Spring for 3,500-lb Trailer Axles - 27" Long #SP-210275 will work with your vintage trailer. It looks from the photo like you would also need the Replacement U-Bolt with Nuts for 2" Wide, Square Trailer Axles -…
view full answer...With how long your current springs are, you will have replace the hangers for the springs to attach to. That being said, this does happen sometimes and it is not the end of the world. The 6-Leaf Double Eye Spring #e27SR will have a length of 26…
view full answer...If you have a Coleman Mach 1, Mach 3 or Mach 15 air conditioning unit then you can use the MaxxAir TuffMaxx Replacement Shroud part #MA00-325001. This is currently the only replacement shroud we offer for Coleman air conditioning units. Since the…
view full answer...Though it would be impossible to tell you what model of Coleman AC you have based on measurements it is possible that the MaxxAir TuffMaxx Replacement Shroud #MA00-325001 will work for you as this is a replacement for Coleman-Mach Mach 1, Mach 3 and…
view full answer...Filter Your Search