How Tight Should Compression Fitting # D13032 Be when Installing a Transmission Cooler
Hi guys! With regards to the compression fitting installation, can you please tell me how tight I should tighten the crush nut and the barb fitting. Do I need to go all the way until no thread is left? | Generally, you will tighten the fittings...
Factory Luggage Rack Capacity Buick 1996 Roadmaster Station Wagon
How much weight can the roof rack or carrier on Buick 96 station wagon Roadmaster hold with out damaging the roof? | I was lucky enough to be able to find a .pdf copy of the 1996 Buick Roadmaster Station Wagon owner's manual online. Buick states...
Hi I have a new Audi Q8 with factory fitted cross bars. Im looking to mount a fishing kayak weighing circa 100lbs flat on top and need suitable cradle system. Please recommend. | To add a kayak carrier to your Audi Q8's factory crossbars you...
Availability of Class III Hitch for 1996 Buick Roadmaster Estate Station Wagon
I have a 1996 Buick Estate Wagon. Looking for a class 3 receiver. Has to fit the wagon not sedan......thanks | We do offer a Class II hitch for the 1996 Buick Roadmaster Estate Wagon with a respectable 3500 lb towing/350 lb tongue weight capacity,...
Replacement Installation Hardware for Draw-Tite # 36105 on 1985 Chevy Caprice Station Wagon
Hi, I am looking for hitch installation hardware for a Hidden Hitch model 90224. It fits on a 1985 Chevy Caprice Wagon. I picked up the hitch at a swap meet, but it didn't have the bolts. | We can certainly help you with that! You'll need...
Trailer Wiring and Brake Controller Recommendations for a 1996 Buick Roadmaster Estate Wagon
I am installing a traler hitch on the above wagon- questions are 1 wireless vs wired controller cost is not a total issue 2 is there an installation Kit for that wagon I suspect it would be the same as a Suburban 3 is the car pre-wired I...
Differences Between Class II and Class III Trailer Hitches
What is the exact difference between a class 2 and class 3 hitch for a 1996 Buick Roadmaster Estate Wagon? Is it strength of materials or design or both? Can I purchase fabrication drawings and specification specifics from you? Any help...
Trailer Hitch Extension for 2 Inch Hitch on 2019 Audi Q8
I have a new vehicle Audi Q8 with trailer ability factory installed. I tow a double jet ski and want to prevent the rear wheels from going in the salt water. I would use the device only on the ramp and not to tow on roads. I was hoping a 36...
Troubleshooting Tekonsha Prodigy RF Not Pairing To 2020 Audi Q8
Hello I am having trouble connecting my prodigy rf to my audi q8. The trailer directly connects to the car with no issue and lights all function, but I cannot pair the controller. I saw a post recently However, I am wondering that since the...
Ball Mount Recommendation For Class ll Hitch On 1996 Buick Estate Wagon
what drawbar will work with the estate wagon class II receiver hitch. Needs to work with a 2inch ball. Thanks | One of the drawbars we offer for a Class ll hitch that fits a 1996 Buick Estate Wagon hitch is the Draw-Tite Ball Mount, part #...
Will E-Z Flex Heavy Duty Rubber Suspension System Affect Ride Height
So I did all my measurements on my trailer to use these to replace current stock ones. One question I have does it lower or raise the height of the trailer at all? The reason I ask is because my stock measurements are 6 1/4 between mounting...
Does a Trailer Hitch Mounted Cargo Carrier Require a Light Kit on a 1995 Buick Roadmaster Wagon
Do I need to have lights wired to my car 95 Buick Roadmaster wagon if the cargo carrier isnt wide enough to obscure the tail lights? | If the cargo carrier and the cargo loaded on it do not obscure the vehicle tail lights, you do not have to...
Recommended Equipment for Towing a Trailer with a 1993 Buick Roadmaster
I tow a 6x12 single axle trailer with my Silverado which has a 2 inch receiver class III hitch. I need a hitch for my 93 Roadmaster sedan Limited that has a 2 inch receiver but I do not see any Class III I do not need the load carrying ability...
Aluminum Ball Mount and Cushioned Hitch Ball for Use with 2021 Kia Telluride
I have 2021 KIA Telluride I have purchased a receiver form you guys and I need to get ball mount and my measurements are 14.25 at the the receiver and the trailer level is 16.0 that being said puts me at 1.75 of rise so I round that up I guess...
Will Wheel Chock # RA-17 Accommodate Motorcycle Tire 23 inches in Diameter
What tire sizes will this chock accommodate? What wheel chicks do you have that will accommodate a 23” diameter tire? | A 23 inch diameter motorcycle tire would not be an issue at all for the Rack'Em Manufacturing Removable Wheel Chock # RA-17...
2 inch Square Receiver Adapter for 1993 Buick Roadmaster
I am trying to adapt a flattend rectangle style class 1 hitch receiver to a 2inch square receiver. Is there anything that could be used to fit that purpose? | All of the hitch receivers and receiver accessories that we offer are square, not...
What is the Outside Diameter of the Hopkins Molded Trailer Wire Connector Part H20046
Can you tell me what outside diameter is of the black cable. I need to buy a rubber grommet to ensure the lack of wearing to cable. | I went to our warehouse to get the Hopkins trailer wire connector # H20046 to provide you the measurement you...
Trailer Hitch Recommendation for a 1994 Buick Roadmaster Estate Wagon
We have been looking for a while now to find a class III hitch for our 96 Buick Roadmaster. Would you know a class III hitch that fits? Or can be made to fit? It needs to pull a 1972 Airstream Argosy of -empty- about 3500 pounds. | We have a...
Trailer Wiring And 7-Way Upgrade Kit For A 2019 Audi Q8
I have a Audi 2019 Q8. It has the hitch but not the wiring harness to power lights on the trailer. Do you have a wire harness I can use for this car? | For your 2019 Audi Q8, you can use the: -Tekonsha ZCI Circuit Protected Vehicle Wiring...
What is Required to Install Draw-Tite Trailer Hitch # C12009 for the 1996 Buick Roadmaster
Hi, Is the installation of this tow hitch pretty straight forward. Meaning do I have to do anything other that bolt to the car, like lower the exhaust? Thank you, | The Curt Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4" Item # C12009...
Winch Mount for Superwinch LT2000 Electric Winch and a 2007 Yamaha Rhino 450 4x4
Will this winch fit onto a 2007 Yamaha 450 Rhino? Do you sell the mounting plate? | Yes, you can use the Superwinch LT200 winch with your 2007 Yamaha Rhino 450 4x4. The custom mount you will need for your 2007 Yamaha 450 Rhino is the Bulldog...
Availability of Trailer Hitch Receiver for 2024 Audi Q8 e-tron
I have a 2024 Audi Q8 e-tron and I'm looking for a hitch that fits. Not sure if there is one or not. Are you able to help me? | There is one hitch available that fits your 2024 Audi Q8 e-tron. That hitch is the Stealth Hitches Hidden Rack Receiver...
Can I Use the Curt Echo Mobile Brake Controller in a 2019 Audi Q8
Will this fit an Audi Q8, getting conflicting reports. | All that is required to make the Curt Echo # C51180 compatible with a vehicle is a 7 way trailer connector with a dedicated 12v charge line. As long as your 2019 Audi Q8 has a 7 way where...
Hitch Confirmed to Fit a 2022 Audi Q8
Is there a hitch option for the 2022 Audi Q8? | There is. The Stealth Hitches Hidden Rack Receiver # 391AUDQ818 is confirmed to fit all models of the 2022 Audi Q8. This hitch is made in the USA, has a bolt-on, no-drill installation and will...
Filter Your Search
Contact and Help