Ball Mount Recommendation For Class ll Hitch On 1996 Buick Estate Wagon
Updated 10/21/2014 | Published 10/20/2014
Question:
what drawbar will work with the estate wagon class II receiver hitch. Needs to work with a 2inch ball. Thanks
asked by: Jeff
0
Expert Reply:
One of the drawbars we offer for a Class ll hitch that fits a 1996 Buick Estate Wagon hitch is the Draw-Tite Ball Mount, part # 36063.
This ball mount fits a 1-1/4 inch receiver opening and uses a hitch ball that has a 3/4 inch shank. This ball mount has a 3-1/8 inch rise from the top of the receiver tube.
The hitch ball I recommend is part # 19258. This is a 2 inch ball with a 3/4 inch shank diameter.
expert reply by:
Jeffrey L
0
Product Page this Question was Asked From
Draw-Tite Drawbar for 1-1/4" Hitches - 3-1/8" Rise - 11-3/4" Long - 3,500 lbs
- Trailer Hitch Ball Mount
- Fixed Ball Mount
- No Ball
- Steel Shank
- Rise - 3 Inch
- Fits 1-1/4 Inch Hitch
- 3500 lbs GTW
- Draw-Tite
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Why Can't Class II Accessories Be Used with Class I Trailer Hitch Receiver
- Article: Trailer Wiring Diagrams
- Q&A: What Gauge Wire does 4-Way Trailer Wiring Use
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Troubleshooting Fit of Curt Hitch C12270
- Q&A: 2025 Toyota Sienna Wiring Needed for the Tekonsha Prodigy RF Brake Controller
- Q&A: Trailer Hitch Fit for 2000 Pontiac Bonneville
- Q&A: Difference Between Curt and etrailer Trailer Hitch Receivers for 2020 Chevy Colorado
- Q&A: Brake Switch Signal Without Tapping into Factory Wiring On 2021 Toyota Highlander For Brake Control
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Article: Dielectric Grease Review
- Article: What Kind of Hitch Do I Need for a Travel Trailer
- Article: Rust Prevention