!Liberty Travel Trailer  x   >   !NX 350h  x   >   !Q70L  x   >   Blazer  x   >  

Does this light serve as a side marker rear light as well? | The GloLight LED Combination Trailer Tail Light - 5 Function - Submersible - 39 Diodes - Driver Side # STL161RLB you were looking at does not have a built in side marker light, so...

Mounting this to a tractor used during snow plow on major road. Do not have a cigar lighter socket. Can this light be hardwired to if cigar plug is removed. | Yes, if you removed the cigarette lighter adapter of the # C4500AW you would have...

My question regards Trailer Tail Light Item # STL8RB. Im replacing running / stop lights that are mounted on a railway motor car speeder. The current lights are mounted on the cab with mounting studs 2 inch on center, the same as the lights...

C7493RTM OUR TRUCK IS 24VOLTS THE LIGHTS ON IT IS V426 WILL THIS LIGHT WORK AND ITS WIRING. WHAT IS THE RANGE VOLTAGE OF THE BULB. | We do have some 24 Volt lights, but the Blazer Trailer Tail Light - 6 Function - LED - Submersible # C7493RTM...

Hello, I want to use this light 24004-7171 as an overhead reading light. Does this light come in colors other than black i.e. white, silver or chrome? also, do you sell an LED bulb that will work in this light? thanks Steve | Unfortunately,...

will this product work on a 30 amp RV. how many light cubes can you hook up and do they all draw the same amount of amps. how long is the suppiled wiring on each cube. | Yes, the Blazer LED Cube Light Kit # BL28VR can be used on your 30 amp...

Will these self-adhesive magnetic mounting plates and here to my fiberglass truck topper the same as it says it will adhere to the aluminum body of the truck cab? | I have a great alternative to the Blazer Amber Warning Light Bar # C4850AW....

Hello, Im building an over-the-cooktop cabinet for my new Cirrus 820 Truck Camper Nucamp wouldnt leave the microwave off the order so I removed it and am looking for 12V DC LED lighting adequate for lighting my cooktop directly below and possibly...

How do toy replace the light? I cannot get the clear Plastic cover off | You'll need a small slot screwdriver to slide into the slot you see the arrow in the picture I attached pointing out to gently pry off the lens. |

Is this light bright enough to be easily visible in bright sunlight. I am investigating this light for use on our 25 vehicle fleet. | Take a look at the demo video I attached below. In it you'll see the Blazer Light # C4850AW installed on the...

I have a Prodigy #0000538575, connected to my 2006 Dodge Ram, 2500, 4WD, Diesel. When I turn off the ignition, the Prodigy lights do not turn off. It was sitting for awhile and ran my batteries down. What can I do? Thanks The first picture...

I need a 360 Amber light for my truck to meet legal requirements in Fl when towing my over width boat. Will this light stay put at highway speed? | Because its low profile leads to very low wind resistance, the 2 magnets used on the Blazer...

I purchased a different brand LED trailer light set. These new lights work fine when the headlights are off. However when the headlights/taillights are on there is no change in brightness. Or no turn or brake lights. I have checked voltage....

My tail lights on my boat trailer keep burning out, Im using a 1156/1073 bulb in the trailer, Can this bulb take a little water? when trailer is backed up to the water to off boat it does get a little water, is there a better bulb? | It really...

Utility function works as advertised, but light does not turn on when I put my 2015 ram 2500 in reverse. Any ideas? | In this case it would seem that your reverse light circuit just might not be properly connected to the 7 way connector on...

I have a 2016 Chevy Silverado 2500. I have a tonneau cover on the bed. The truck has fifth wheel seven pin plug in the bed. Is there a plug-in light available for a 7 pin receptacle that uses the blade that is always hot that I can turn on...

I bought the Blazer LED submersible trailer lights for an old trailer. Wired everything correctly for about and an hour and a half and got nothing. So I took a grinder to the ground spots and the good lord said let there be light! I now have...

What fuse runs the center pole on a 2013 duramax | The center pin on a 7-way trailer connector should be responsible for the reverse lights on the trailer. I looked in the owner's manual for your 2013 Chevrolet Silverado 2500/3500 and this circuit...

what are the exact dimensions of these plates and can they fly off in the wind? | The Buyers Products Magnetic Mounting Plates # 3378895404 that you referenced measure exactly 3-1/2" x 3-1/2". These feature strong 3M tape strips on the backside...

I have a set of these lights, and everything works except the right-hand side marker. Is it possible to open the case for a possible repair? They seem permanently sealed. | First check to make sure the light is grounded properly. That is typically...

All the lights but the parking lights are working. I have flashers, right and left blinkers, brake and backup lights, but no parking lights. | Try connecting a known working 12 volt power source to the brown wires of the Blazer LED Trailer Tail...

Wondering if the bulb can be replaced and if so how. | The Blazer Trailer Tail Light # C7493RTM is an LED assembly which means that the bulb isn't replaceable, but due to how long LEDs last you really wouldn't have to worry about that. Unlike...

Could this be hard wired as well as permanently mounted? | If you cut off the cigarette lighter portion of the Blazer Mini Amber Warning Light Bar # C4855AW you'd have two wires that you could then hardwire if you wanted to. Also if you wanted...

if you cut off the cigaret lighter to hardwire it how do you get the different flash patterns | That's not something I'd really recommend honestly. You'd have to take apart the end of the power port so that you could get the wiring after the...