Availability of Dexter EZ Lube Spindle Nut 006-190-00
Do you stock the Dexter E-Z lube spindle nut retainer part # 006-190-00? I am ordering several other parts from you and I can not find this part. | We do have what you are looking for but it is our part number # 6-190. |
16'1" Replacement Awning Fabrics With a Black Weather Strip When Rolled Up
Does the 16'1" awning fabric with the black weatherstrip come in silver or is it sand only? | The only Silver Fabric # LCV000334413 we have is going to fade to a white weather strip. The Sand # LCV000334407 you found, Black # LCV000334409 and...
Replacement Wiring Harness for Lippert Ground Control 3.0 System
Need a couple of the 3 pin connectors that goes in to the board where all the jacks plug in | The connector you sent in a picture of appears to be the wiring harness from a Ground Control 3.0 system like part # LC307490. We don't have a way...
Troubleshooting an ACMHD Heat Strip in a AC135SP A/C Unit
My RV has an Advent AC135 AC135SP non-ducted A/C unit. I purchased a ACMHD heating element and installed it in my unit. Installation was very simple. A few screws to mount it inside the unit and plug it in to the connecter for the heating...
Will Grease Seal GS2125DL Replace Seal that Measures .375 inch
My current seal has a thickness of .375inch and the replacement part GS-2125DL has .31. Does that matter? Also, the grease caps I ordered 2.44inch OD RG04-080 using the vehicle feature mode on etrailer does not fit my 6K lb Dexter axle. Those...
Does the Replacement Dome Assembly # BVD0449-A01 Come with the Seal/Gasket
Im looking at a rV vent #bvd0449-a01 does it come with a gasket? Thanks | The Replacement Dome Assembly # BVD0449-A01 that you referenced does not come with a gasket - it is the replacement lid only. For the seal, or gasket, you will want...
Availability of Flush Mount Fireplace for 33" x 19-3/4" Opening
Can you help me find a rv fireplace that would fit into a 33 x 19 3/4 opening. Flush mount. thank you! | The closest fireplace we have to what you are looking for is the 34" Furrion RV Electric Fireplace with Logs # FF34SW15ABL which needs...
What is Needed to Pack Bearings on Trailer
I have a 2021 Keystone Laredo 325RL 5th wheel. What do I need to repack the bearings? I have never done this on an RV so once I start i want everything I need on hand | In order to re-pack the bearings on your trailer, all you will need is the...
Can Curt Echo Mobile # C51180 be Used on iPhone 5s
Wanting to use on a 2017 Fleetwood Pace Arrow LXE 38’ motorhome. Will the C51180 work with an Apple 5s phone? | Yes, as long as you have the latest iOS on your Iphone 5s the app needed to use the Curt Echo Mobile # C51180 will work and run...
Troubleshooting 2010 Keystone Laredo 245RL Landing Gear Blowing Fuses
Hello, I have a 2010 keystone Laredo 245RL 5th wheel and just recently while trying to leave the camp ground the landing gear motor would throw 30 amp fuses while trying to raise the camper. The motor would run fine then slow down and blow...
Crank Extension and Crank for Lippert RV Spare Tire Carrier with Winch
Does the crank extension stay connected to the winch? If so, what keeps it from moving and banging around? If not, how does the crank extension connect to the winch? Thanks, 2017 Keystone Laredo 342RD 5th wheel. | The Lippert Components RV...
Replacement For A Recessed Puck Light With A 03-HPG 46 LED Light Bulb
I have a 2016 Keystone Laredo and the pick lights above my couch and recliner have faded out. I measured the lens and it’s closer to 5” but the base opening is 3”. Mine also have only 6 led lights …can you suggest a proper replacement? | We...
Replacement Front Jack for Lippert Ground Control 3.0
Hello, I am looking at your part 179013 and 179014. I have 3.0 Grounding and they do not look the same and could you tell me if you carry a replacement part for my leg. My legs have motors mounted directly to the leg. Keystone Larado 2018...
Recommended Self Adjusting Brakes for Al-Ko 4,400 lb Axles
I have a 2013 Keystone Laredo 5th Wheel 289SRE— I am looking for the self adjusting brakes and the drums for it. I’m thinking they’re 4400 pound axles. | Michael, so you are correct you do have 4,400 lb axles so you can use the Dexter Nev-R-Adjust...
Tekonsha Brake Controller and Wiring Harness for 2017 Fleetwood Pace Arrow LXE Motorhome
What do I need for brake controller This is a freightliner chassis with air brakes | For your 2017 Fleetwood Pace Arrow LXE Motorhome, I recommend the Tekonsha Primus IQ Trailer Brake Controller item # TK90160. This is a proportional brake...
Selecting The 3 Step or 4 Option of the TorkLift GlowStep Revolution Scissor Steps w/ Landing Gear
When measuring the factory steps on my 2013 Keystone Laredo 329 RE, I definitely need the 27inch wide assembly. My question is whether I need 3 steps or 4. The height of the mounting bracket is 33inch when level on a concrete pad. I believe...
Replacement Motor for Landing Gear of 2008 Keystone Laredo
Will this part fit my 2008 keystone Laredo fifth wheel | If your 2008 Keystone Laredo has a landing gear set that is the brand Venture, Lippert, Power Gear, or LCI this # LC142178 is most likely a fit but without knowing for sure what brand...
Replacement Bearings, Races and Grease Seal For Dexter 4,400LB Axle Under 2021 Keystone Laredo
I have a 2021 Laredo 255srl fifth wheel with Dexter axle no: 248744 of 4400 lbs and I would like to know the part numbers of the internal and external bearings, race complete set beauring, race, seal Thank you Jai une fifth wheel Laredo 255srl...
Upgrading the Coleman MACH Airxcel Rooftop AC on a 2013 Keystone Laredo 5TH Wheel Camper
I have a Keystone 2013 Laredo 5th wheel with an Airxcel 48000 series ac unit and a coleman mach thermostat. I want to upgrade to a bigger unit. Can you recommend what will be needed to do this. | Without knowing the exact model number on your...
Where Does Gooseneck Hitch Ball Normally Sit in Bed of Truck
What distance from the front bed rail does the gooseneck ball in trailer need to be. | Ideally the gooseneck hitch ball gets centered right above the rear truck axle or sometimes up to a couple inches forward from that point. This puts the pin...
What Replacement Snap Pads Will Work With My Lippert Ground Control 3.0 9 Inch Round Feet
We have the Lippert Ground Control 3.0 jacks on our 2021 Keystone Laredo 5th wheel. The jack feet on the back are 9 in. round but the front are 8 1/2 to 8 3/4 in. round. Will the 9 in. Snap Pad fit both front and back with the difference in...
Replacement Sewer Hose for RV Blackwater Maceration System
I tried to adapt the extension hose to a garden hose type connector, crushed the fitted/shaped end of the hose to where I could no longer use this part. I trimmed the hose like you would to a garden hose, but I trimmed the shaped end off completely...
What Parts Do I Need To Install My New Tankless Water Heater With The Pressure Relief Valve In Back
My present hot water heater has the pressure relief valve venting out of the front of the unit. Thoughts on how to work the logistic of routing the vent plumbing from the back when replacing with a tankless unit? | You will use Camco RV Water...
How To Wire A 12V DC Tankless Water Heater In An RV That Previously Had A 120V Water Heater
I currently have a gas electric hot water heater. The electric is 120 volt. The tankless units are gas and 12V DC. Will I need to find or run a 12V DC source from somewhere or should there already be a 12V DC source at the present unit.? | For...
Filter Your Search
Contact and Help