Replacement Windshield Wiper Blades for 1997 Lexus LX 450
Why is one 16inches and one 18inches when both should be 18? 1997 lx 450 is the vehicle. is the scrubblade bigger? and has clearance issues? | Actually, Scrubblade recommends the # SC87FR 18 inch blade for the driver side and the # SC67FR 16...
Recommended Trailer Hitch for a 2009 Nissan Cube
i have a 2009 nissan cube. i saw a picture of a hitch for a 2010 cube. Do you offer it for the 09 and also is the hitch installed above the exhaust or below? | The 2009 and 2010 Nissan Cube models use the same hitches. The Curt hitch # C11202...
Installing the Hopkins Smart Hitch Backup Camera on a 2013 Ram
I have this camera but it doesnt work on my 2013 Ram. Why not? | We have learned that the 2013 and newer Ram trucks do not provide enough voltage to power the Hopkins Smart Hitch, part # HM50002, simply by plugging it in to your truck. In...
Left Signal on Trailer Flashes when I Indicate Right Turn
I have a 96foot LX450. When I signal a left turn all works as it should. When I signal right, the lights on the right side passenger side of the trailer go out and the left turn signal blinks on the trailer. All the lights work properly on...
Can A Bike Rack Be Installed Using Curt Class I 1-1/4 Inch Hitch # C11202 On 2009 Nissan Cube
Can bike rack be installed using this hitch? | A bike rack can be installed on the Draw-Tite Class I 1-1/4 Inch Hitch # C11202 on your 2009 Nissan Cube, but you will have to be sure that the bike rack is made to fit a Class I hitch. Because...
Recommended Tire Chains For Off-Road And Snow Use On 1996 Lexus LX450
Please recommend snow tire chains for my 1996 LEXUS LX450. The truck has a 2inch lift for additional ground and tire clearance. Tires are Goodyear Wrangler Duratrac 265/75-16. The chains will be used on four wheels on snow and ice covered paved...
Draw-Tite VS Curt Class III Receiver
I have a 1997 Lexus LX450 with the Draw-Tite Class III receiver installed. It has been there for quite a while and is has rusted so I thought it was time to replace it. I would like some information on Draw-Tite vs Curt for the class III receiver....
What Size Dowel Nuts Do I Need for My Vehicle?
Where can I find the dowel nut replacement bolt for gutter mount. Its for an 1996 landcruiser | We do have plenty of replacement dowel nuts like the Replacement M6 x 16 mm Dowel Nut for Rhino-Rack Accessories # RR56TB which are M6 x 16 mm threaded...
Is there Any Drilling Required to Install Curt Trailer Hitch # C11202 on a 2009 Nissan cube
Do i have to drill at all? Frame or hitch | To install the Curt Trailer Hitch Receiver, # C11202, on a 2009 Nissan cube, you will need to enlarge holes that are already there, not drill new holes. I have included a link to the installation instructions...
Do Factory Bump Stops have to Be Cut to Install Air Lift Air Bags on a 1997 Lexus LX450
Hi! Do I need to hack off part of the bump stop for this installation? Please send install procedure specific for a 1997 Lexus LX450. | Yes you will need to trim away the factory bump stops to install Air Lift helper springs # AL60728 on your...
Brake Controller Installation on 1997 Lexus LX 450
looking for a Prodigy direct plug in wiring harness for a 1997 Lexus LX450. Do they make one or do I have to use a universal and wire it myself? | The 1997 Lexus LX450 was not factory equipped with the connector under the dash for a plug and...
Can The 7-Way Trailer Connection Be Used To Power Winch If Vehicle Is Running
Can the 7 pin plug be used to power the winch if I have my truck running? | The wiring that feeds the 12-volt accessory circuit on the 7-way trailer connector is of too small a gauge to allow enough power to pass through to run a winch. The...
Filter Your Search
Contact and Help