Hitch Size that Fits 2011 Chevy HHR
Can a 2 inch receiver hitch go on a 2011 HHR? | For your 2011 Chevy HHR there are only 1-1/4 inch hitches available like the Curt # C11447. The 2 inch hitch size is only available on higher capacity vehicles like trucks and SUVs. I attached...
Wiring an RV with Separate Brake and Turn Signals to a Chevy HHR with Combined Brake/Turn Signals
I have separate brake lights and turn signals on my 07 dodge sprinter based motor-home. They are also separate on the 6-pin wired plug. Im am towing a 07 Chevy HHR that is wired with the flat 4-pin plug. How do I get the brake lights to work...
What Will I Need to Economically Flat Tow My 2006 Chevy HHR
Need basic tow set up Base Plate and Towbar on the low cost end for a 2006 Chev HHR . | A tow bar you could use to pull your 2006 Chevy HHR is the RoadMaster Tracker Tow Bar, part # RM-020. You may also be interested in purchasing a Roadmaster...
Amber Version of the Clearance Light part # MCL98RB Availability
Sealed, 3-Light Truck, Trailer Identification LED Light Bar, Black Base, 50inch Lead, 9 Diode -Red You dont have ID LED lights with amber lights. Can I use the above lights on front and back or do I have to have the amber in the front? Thanks,...
Does SuperChips Programmer Flashpaq part SU4845 Fit 2008 Chevy HHR SS
I bought a superchips programmer for my 2008 HHR SS but I could not get it to work. Does the Edge unit come with the program already installed? If so which unit should I purchase for this application? | For your 2008 Chevy HHR SS the Superchips...
12 Volt Power Socket for 2008 Chevy HHR Being Flat Towed and How to Maintain Battery Charge
I have the tail lights wiring installed4way flat need a 12 volt socket installed for brake want it all tied into the adapter from the motor home need new adapters and coil wire connector from MH to toad also will I I need a maintance charger...
Can 2008 Chevy HHR with Automatic Transmission be Flat Towed Behind RV
can a 2008 hhr chevrolet automatic be flat towed | I looked up your 2008 Chevy HHR with an automatic transmission and it can be flat towed as-is as long as you follow all of the guidelines in the owners manual and stay under 65 MPH. To flat...
Recommended Base Plate to Tow Bar Locking Pin Keyed Alike
When I could not get one of these to unlock I was forced to take a grinder to it. I therefore have one pin. I assume that I cannot get another pin whose lock is the same as I have and do not need the receiver pin in the blue ox kit. I flat tow...
Brake Lights for Trailer, Cargo Carrier, and 2008 Chevy HHR
i tow a tera trailer with a cargo carrier on the rear it blocks my taillights so i put some on the carrier . since the car lights are controled by the body control module it wont handle the second extra set of lights is there a cure for this,...
Ball Mount Recommendation to Clear the Back of a 2007 Chevy HHR
It seams after careful measurement that using this unit #C45014 it will give me only 1inch or slightly less clearance from the ball platform to my bumper. Is this enough clearance or should I purchase the #C45015 with what appears to be an additional...
What Wiring Kit and Diodes are Needed When Flat Towing a 2010 Chevrolet HHR
What wiring kit and diodes do I use on my 2010 HHR? What is the cost? Where do I order them? | Your 2010 Chevrolet HHR has a 2-Way (combined) wiring system which means the brake and turn signals are sent along the same wire. If you will be...
Supplemental Braking System Recommendation for Flat Towing Vehicle w LED Indicator in Tow Vehicle
I have a 2006 Chevrolet HHR that I used to tow with a motor home. It has the Roadmaster InvisiBrake Supplemental Braking System installed on it. In the motor home, the installer put in a tiny light that was activated whenever the HHRs brakes...
Roadmaster 2nd Motorhome Monitor Recommendation for New RV Towing Vehicle with Invisi Brake
I have a 2006 Chevrolet HHR that I used to tow behind a motor home. Before ordering this cable, I want to make sure it will work to connect another motor home to the HHR. There is now a 4 pole male round plug attached to the HHR that was used...
Trailer Hitch Receiver For 2011 Chevy HHR For Use With 2 Inch Bike Rack
Looking for a trailer hitch for a 2011 Chevrolet Hhr To accommodate my bike rack the trailer hitch that Etrailer recommends has a 1 1/4 opening and my bike rack needs a 2 inch opening any suggastions | The only trailer hitch receiver for your...
Do I Need to Trim The Rear Fascia of my 2010 Chevy HHR SS to Install the Draw-Tite #24756
the hitch says it will fit the ss model hhr. Is this done without cutting the rear bumper. I remember seeing once a while back modification to the bumper was required just wondering if this was still the case, thanks. | Yes, you will need to...
How to Use the Lights of My 2006 Chevrolet HHR on a Tow Dolly Behind an RV
I PULL A CAR TOW DOLLY which I plug into the flat 4 connector on my motorhome which is on an F 53 chassis. THE dolly has a flat 4 wired to the brake and turn signals. If I wire my 2006 chevy hhr with the C55432 and plug the flat 4 from it into...
Could I Install Base Plate Kit # 3141-1 on a 2010 Chevy HHR, Would I Need to Remove My Front Fascia
I traded my 2007 HHR for a 2010 HHR. Have base plate Roadmaster installed on 07 and want to transfer it to the 10. Does the whole facia and bumper have to come off? The RV dealer installed the 07, but I want to transfer myself to save $900. Please...
How to Carry a Trike on a 2007 Chevy HHR
Im new at this: What type of rack would work on my HRR to transport my 26: Meridan Tricycyle. I have no trailor hitches on the car. Also, information on having it installed. If it is easy to install my nephew could probably do it. However...
Is a Supplemental Braking System and Breakaway Required for Flat Towing in the United States
do I need a breakaway system on my 2006 hhr if I am going to flat tow it in Montana, Nevada, Utah or California | Yes, pretty much all states (with the exception of Missouri for some reason) and Canadian provinces require that a towed vehicle...
Parts Needed to Flat Tow 2008 Chevy HHR
Have a 2008 chevy HHR with a brake buddy have bypass switch and Hopkins wiring kit 56100 what else do I need? Do I need the brake switch 751428 and 12 volt outlet and brake relay | You will need a base plate on your 2008 Chevy HHR to flat...
Increasing Performance on 2010 Chevy HHR SS
Does the Superchips Flashpaq # SU4845 work on the 2010 HHR SS? I ran this tuner on my 2008 Chevrolet HHR SS but I sold that vehicle and gave the tuner away with it. Now I have a 2010 HHR SS but cant find anywhere that says if its compatible....
Needing Receiver Hitch for 2008 Chevy HHR SS
I see you have a hitch for the HHR, my question is do you have one to fit the HHR SS. The HHR SS has a different bumper in the back. Mine is a 2008. I called this week and the friendly woman said it would, but I would like to be sure. If you...
Troubleshooting Trailer Wiring on a 2015 Ford Transit T350
2015 Ford Transit 350. No factory trailer light/brake wiring. Tekonsha Prodigy P2 brake controller already installed. Can the wiring adapter be used with a 7-pole plug by cutting off the flat 4-pole and matching the wires to the appropriate...
Parts Needed to Flat Tow 2019 Jeep Cherokee Limited, Latitude or Latitude Plus
What all will I need to flat tow my 2019 Jeep Cherokee? I'm not sure which model I have. | For your 2019 Jeep Cherokee you'll need to first start with a base plate kit. For that you'd want the part # RM-521452-4. This fits the Latitude, Latitude...
Filter Your Search
Contact and Help