How to Use the Lights of My 2006 Chevrolet HHR on a Tow Dolly Behind an RV
Updated 09/07/2016 | Published 09/06/2016
Question:
I PULL A CAR TOW DOLLY which I plug into the flat 4 connector on my motorhome which is on an F 53 chassis. THE dolly has a flat 4 wired to the brake and turn signals. If I wire my 2006 chevy hhr with the C55432 and plug the flat 4 from it into the dolly will my lights on the car work as brake and turn signals.
asked by: Len W
Expert Reply:
It sounds like you want to use the lights on your 2006 Chevrolet HHR instead of the lights on your tow dolly when towing your vehicle. If this is the case, you will need the Hopkins Tail Light Custom Wiring Kit # HM56100. This will allow you to connect the HHR directly to your motorhome and power the lights instead of the dolly.
The Curt T-Connector Wiring Harness # C55432 you asked about is what you would use if you were towing a trailer with the HHR.
I've attached a video showing the installation of the Hopkins harness.
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- No Converter
- No Tow Package
- 4 Flat
- Plug and Lead
- Plug-In
- Hidden
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: The Best Electric Trailer Jacks of 2025
- Q&A: How to Check for a Bent Trailer Axle Spindle
- Q&A: Torque Specification for Lugs Nuts on 5/8-Inch Stud on Dexter Hub
- Q&A: How To Flat-Tow a Chevrolet HHR SS
- Q&A: Plug-In Tow Bar Wiring for a 2007 Chevy HHR
- Q&A: Recommended Parts for Flat Dinghy/Recreational Towing a 2008-2010 Chevy HHR
- Q&A: Replacement Control Board for Dometic RV Rooftop Air Conditioning Unit
- Q&A: What Fluid to Use with Lippert Hydraulic Jack Leveling System