Replacement Axle and 5 Spoke Utility Hubs for Older Triple Axle Trailer
I have an older triple axle deckover equipment trailer that has the Utility 5 spoke drums on it. One of the axles needs to be replaced and I want to replace with another straight beam axle and just buy new 5 spoke utility hubs to fit it so...
Will the Timbrens Help with Worn Out Leaf Springs on a 2005 GMC Sierra 1500
My rear leaf springs are worn out on my GMC Sierra 1500. Would these help with my old leaf springs, or should I replace my leaf springs and then add these Timbrens? | If the leaf springs on your 2005 GMC Sierra are worn out then the Timbren...
Trailer Hitch for 2003 GMC Sierra 2500HD with Additional Drop
I prefer the extra that the # BWHDRH25187 has over the recommended replacement # BWHDRH25182 for my vehicle, as I do not want the receiver directly under the bumper as is shown for #25182. So will the # BWHDRH25187 bolt up to my truck as it...
Can Factory Brake Controller of 2009 GMC Sierra be Bypassed with Prodigy P2
Will the Tekonsha plug in wiring adapter plug into my factory brake controller harness? I have the 7-way plug. My TBCM failed and I want to install a Prodigy P2 controller | You can bypass the factory brake controller of your 2009 GMC Sierra...
Will GM Cargo Management System Prevent Access TonnoPro Tonneau Cover Install on 2010 GMC Sierra
What is a cargo management system on a 6ft 6 in bed | The cargo management system is an optional track system mounted in the truck bed on the inside of the bedside up near the top. The presence or lack of this system will influence the fit of...
Required Clearance from Tire to the Frame of a Boat Trailer
HOW MUTCH CLEARNCE DO I NEED FROM THE SIDE OF MY TIRE TO THE FRAME ON A BOAT TRAILER | The general recommended "sweet spot" for clearance between the side of your tire to the frame is 1-2 inches from the inside edge of the tire to the frame. |
Can Demco Hijacker Autoslide for Ford Rail Kit Fit 2012 GMC Sierra
I know I don’t have to drill holes in my frame. I meant to I have to drill holes in the Reese rails between the frame rails to be able to mount the gooseneck ball? I don’t see any mounting area for it. | If you had the Demco Hijacker for Ford...
Which SumoSprings Suspension Enhancement Kit for 2001 GMC Sierra 2500HD with Camper
I am carrying a truck camper with a wet/loaded weight of approx 2200# gvwr allows 2300# as configured this places approx 2700# load on each rear wheel vehicle and camper...which Sumo Spring product do I want? FYI what isnt clear is if the...
Is all the Installation Hardware Included with the Curt A20 Fifth Wheel Hitch C16536
I want to purchase and install the Curt A20 Fifth Wheel Hitch C16536. Does it come ready to install out of the box complete or do I need an installation kit? 2010 2500HD GMC crew cab reg 6 bed | The Curt A20 Fifth Wheel with Slider, part #...
Where Are Draw-Tite Hitches Made?
Fracture model # 41944 where is it made USA? | The Draw-Tite Ultra Frame Trailer Hitch Receiver w/ Cast Center # 41944 for your 2004 GMC Sierra is made in Mexico. However, Curt hitches like Curt Trailer Hitch Receiver # C15312 are all made...
Replacement Hardware for Truck Steps
The 2 bolts fell out of the front mount of my tube. How can I get 2 replacement nuts so I can replace the bolts? | It looks like you are looking at replacement hardware for steps. If you want the hardware for the Bestop TrekStep Truck Bumper...
Will a 3/8 Hose Fit an 11/16 Inch Fitting to Install a Transmission Cooler on a 2006 GMC Sierra
Please excuse me if this is a ridiculous question, but does 3/8inch rubber hose fit properly over the slightly smaller 11/32inch cooler fitting, or must I use 11/32inch hose? The existing steel cooler lines from the transmission of my 2006...
How to Replace the Factory 7-Way on a 2006 GMC Sierra 2500HD with No Connector
I am replacing a 7 way and 4 way plug on my 2006 GMC Sierra 2500HD and someone cut the factory plug off the wire harness under the rear of the truck. Will this item replace the factory wire harness plug so I can use a trailer plug like 30955...
Tonneau Side Rail Dimensions for 5th Wheel Pin Box Clearance
Have 2006 GMC 3500 long bed dual rear wheel SLT Sierra truck. Looking for a very low profile roll up tonneau cover. I have a fifth wheel hitch installed in the truck bed. I need to verify the tonneau cover clears the 5th wheel hitch when...
Replacement Cover for Extang FullTilt Tonneau Cover on 2006 GMC Sierra w/ 6-1/2 Foot Bed
Just checking to see if #37940 is the correct replacement tarp for my Extang Full Tilt Snapless tonneau cover, my truck is a 2006 GMC Sierra with a 6 1/2 foot bed. | If your FullTilt tonneau cover is part # EX38940, then the # EX37940 replacement...
Where Do Fifth Wheel Rails Install In Bed of 2003 GMC Sierra 2500 Long Bed
I need the measurements on where the rails go for a 2003 gmc 2500 long bed. | For your 2003 GMC Sierra the fifth wheel rail kit that fits your truck is the Reese part # RP50064-58 and the front rail will install 52-3/8 inches from the rear edge...
Tee and Hose for Tapping Into RV Propane System Before Regulator
I would like to add a quick connect fitting on the outside of my RV to run various grills and cookers. I was going to tap in before the regulator on the existing tank and run a high pressure feed to a quick connect fitting. I am planning on...
Compatibiltiy of Front Mounted Trailer Hitch on 2008 GMC Sierra 3500 Dually Not Cab and Chassis
Difference for Dually?I have had an issue with ordering based on “this fits your 3500”.... just wanting to clarify this will fit a ‘08 Sierra 3500 DRW. And that there is no difference between the cab and chassi version and the pick up version?...
Brake Controller Wont Power Unless Brake Pedal is Pressed on 2000 GMC Sierra 1500
I bought a Hopkins e- brake controller and adapter plug to go to my factory installed tow package in my 2000 Gmc Sierra 1500 4×4 z71. Only get power to my elct. brakes when I step on the brakes but they are on full, no light on controller as...
Recommended Wiring and Mount for Redarc Liberty Trailer Brake Controller on 2002 GMC 1500
In the in useinch photos of the Redarc controller installed in Toyota 4Runner, do you folks know where the small rectangular panel with the trailer brakeinch lettering molded into it was sourced? Im interested in switching to this controller...
Will the Buyers Products Combination Hitch with Mounting Kit Fit on a B&W Pintle Hook Plate
Want to confirm this part: Item # 33710055 will bolt directly to and work with Item # BWPMHD14001 for a 16k lb rated pintle and 2 5/16inch set up. Thanks. | Yes. The B&W # BWPMHD14001 is compatible with the Buyers Products # 33710055 since...
Will MagnaFlow Exhaust be Too Loud in the Cab of a 2004 GMC Sierra 1500 5.3 Liter
Iam wanting a nice sound, but not alot of drone in cab, but not a sissy sound, like the stock muffler,is this what i would want ? I have heard flowmaster 40s are to loud | MagnaFlow exhaust such as # MF15778 has an aggressive, throaty sound....
Compatibility of Demco Recon Fifth Wheel Trailer Hitch with Revolution or Sidewinder Pin Box
I recently purchased a demco recon hitch from you it is being shipped now and the trailer I just purchased has a reese revolution pin box. Therefore, I assumed I did not need a slider type hitch for my 2012 GMC 2500hd denali. Then I read where...
Functions of Wire Colors on Miro-Flex Clearance Light part # MCL48AB
Miro-Flex LED Trailer Side Marker Light and Mid-Ship Turn Signal - Submersible - Amber Lens Item # MCL48AB I seem to having with the video and transcript does show. Red, white and black wires. Which is ground? | For the Miro-Flex part # MCL48AB...
Filter Your Search
Contact and Help