How to Determine Original Tire Size of 1993 Terry Resort 5th Wheel
what size tires do I need to put on my 93 terry resort 5th wheel camper? | Terry brand trailers ceased operations after the 2009 model year, so unfortunately it's not possible to contact the manufacturer. I was unable to find anything online...
Replacement Landing Gear Set for a 1991 Avalon 5th Wheel Trailer
Need landing gear Assy. For 1991 avalon 35.5 b | To choose the correct replacement landing gear set you simply need to determine the spacing between the weld stops on your current landing gear set. The standard measurement is 15-1/2" inside...
Replacement Conversion Kit For Motor For # 781005
I have a 1988 fleetwood pace-arrow. The step motor is bad and the number on the motor is #1697345. Is the conversion kit # LC29VR, what I need to get the steps working again? Lippert Kwikee gave me a conversion # 781005. My steps are a two step,...
Recommended Axles for Classic Camping Trailer Measurements
A group of us are looking to replace the double axle and suspension on a 1980s Terry taurus trailer according the measurements on the frame it is 66inchs on center what axles would you suggest? Thanks and hope you can help. | Based on the 66...
Troubleshooting Lost Power on a 1993 Fleetwood Limited RV Outlet with Generator
when plugged in I have power to my control center but no power to the outlet that my converter plugs into. when I plug the converter into a 120v alternative source then everything works fine. when i run the generator all works. Does this mean...
How to Select the Right Tires for Fleetwood Wilderness Trailer
I am wondering what type of tire I need to replace the old ones on my 1990 Wilderness Yukon by Fleetwood? I just bought it used and it has all different tires which explaines the blowout. Any help would be awesome. | The right tire for your...
Recommended Suspension Enhancement For A 2008 Fleetwood Bounder 32K
Hi, I'm a new entrepreneur and run a small mobile business out of a 2008 Fleetwood Bounder 32K motorhome. This business requires me to travel over some pretty rough terrain and sometimes go off road. The ride quality is terrible and has broken...
Picking Out Replacement Trailer Leaf Spring Info Needed
I need new leaf springs for my car trailer. My old springs are 1 3/4” wide and 14” from the mounting bolt to the centering pin and have 5 plates total that make up the spring. | Without knowing what axle capacity you have it's hard to say exactly...
Correct Steering Stabilizer for a 1989 Fleetwood Limited Motorhome
Im needing to replace the Firestone air helper springs on the front. Wanted to know what you recommend best for my application? Perhaps you can also tell me the correct steering dampener for my application as well? I noticed there is a few choices...
What Is The Difference Between A Disc Brake and Drum Brake Surge Brake Actuator?
I see the DM64VR comes with electric lock out for reverse and it is for disc brakes And the DM72VR doesnt come with electric lock out for reverse and its for drum brakes What makes them different to use for drum brakes? I have drum brakes...
Could Optronics Trailer Clearance Lights A32AB and A32RB Replace SAE-A-P2-83
Hi, I am wondering if this item number will work on my camper? A32AB and A32RB The writing on one of my current red light covers is SAE-A-P2-83. Thank you! | The SAE number of a trailer light isn't a reliable way to ID them as it's not a...
Can a Hayes 10 x 1 5/8" Braking Assembly W/ No Mounting Flange Be Converted to a Standard Flange
I employ a 1990 Wilderness Yukon with tandem 3000 lb Hayes axles with 10inch X 1-5/8inch brake assembly and hubs with 5 on 4-1/2inch spread. I saw your 10inch x 1-1/2inch brake assembly but with a 4 bolt backside. The existing mounting plates...
Help Picking Out Hub/Drums and Brake Assemblies for 1986 Avion Model 25-H
Hey, I have a 1986 Avion model 25-H travel trailer and it needs allot of work on the wheel assemblies. Im really not too familiar with wheel assemblies on vehicles so I was hoping that I could get some advice on what to get. Pretty much everything...
Can Support Bar That Runs in Bracket Track on Lippert Manual Pull-Out Step Be Removed
I cant tell from any of the photos – can the step detach from the mounting bracket that holds the assembly to the trailer? I cant tell if there is a cotter pin holding the bar in place which would allow for easy detachment of step from mounting...
Replacement 7-Inch Hub/Drum for 1993 Coleman Cape Cod Pop-Up Tent Trailer
I am looking for replacement hub assemblys for a 1993 Coleman Cap Cod tent trailer that have a part# of 4716A1071. Do you have a match for this? | My research indicates that the Coleman part 4716A1071 refers to a Dexter 7 x 2-inch hub/drum with...
Will The Dometic Ultra Breeze Trailer Roof Vent Cover Work With The Fan-Tastic Vent Model # 2250
Just bought fantastic vent 2250 model wanting to get cover for use in rain will this model vent cover the vent and will it allow it to be used when vent is fully open | The Dometic Ultra Breeze Trailer Roof Vent Cover # DMC38FR is designed to...
Upgrading to 12" Wheels and Tires on 1993 Coleman Pop Up With 5.70-8 Tires
I have a 93 Coleman pop up and it has 5.70-8 on it I would like to upgrade to a 12inch rim but dont know what one to look at for that size | Replacing your tires with a larger size on your 1993 Coleman camper is a matter of having enough clearance....
16" X 6" Trailer Wheel With 1/2" Positive Offset For Mounting With 8 on 6-1/2" Bolt Pattern
Hello, I need a 16 x 6 inch steel wheel, modular design, I put a 16inch straight edge along the back of the wheel on the outside of the bead, and measured to the hub face and got 4. I suppose if I was measuring from the inside of the bead to...
How To Determine The Correct Fitting Door Handle/Lock For Your RV
Locked out of our Bounder, sent kid through the window, door wont open from inside either. I just want to make sure I order the correct part so we can replace it once we actually get the door open. Thank you | The only way to know if a door...
Will The DMC84FR Door Conversion Kit Fit A Fogatti Tankless Water Heater
Will this DMC84FR work with a fogatti FS06B1? Im wanting to install it on a 1988 Fleetwood Bounder. The original one is a Atwood 6 gallon. Not sure which model. The plate is worn and unreadable. I know the opening is 16 1/4 X 15 5/8. | I contacted...
Replacement Motor, Gearbox and Linkage for Kwikee Series 32 Steps Pre-1995
Have a 1993 Pace Arrow with a two step Kwikee assembly for the entrance door. The motor whirs but the gear drive does not operate the arm to extend and retract the stairs. The information tag on the stair frame is not completely legible but...
Filter Your Search
Contact and Help