Will a 4.80-8 Trailer Tire Fit in Place of a 4.00-8 Tire
I have seed planter with implement tires of 4.00 x 8. Will a 4.80 tire fit? | Yes, a 4.80-8 tire will fit in place of a 4.00-8 tire. That is why a lot of times you will see both sizes in the product's title or description and even on the actual...
How To Carry Two 50 lb Mountain Bikes With A 2017 Nissan Maxima
I have a Nissan Maxima 2017 I am looking to buy a trunk rack that can hold two mountain bikes Wt about 50 lbs each.I see that the trunk bike rack look to hold 35 ponds each bike. Can buy a Saris Bones EX 3 for 3 bikes and just load 2 bikes...
Hitch Fit for 1996 Nissan Maxima
CAN A UNIVERSAL MULTI-FIT CURT HITCH 13900... Or ANY NON-CUSTOM FIT HITCH... Be Used On 1996 Nissan ??? | The only hitch fits we can guarantee will work on your 1996 Nissan Maxima will be custom fit hitches like the Curt part # C11255. The universal...
Trailer Hitch Receiver Fit for a 2002 Nissan Maxima
Hello and hope your day is going well. Do you know if the Nissan Maxima 2004 hitch will also fit a 2002 Nissan Maxima ? thanks, take care | Hey Romney, my day is going pretty well! The Curt Trailer Hitch Receiver # C11264 only fits a 2004-2008...
Troubleshooting Trailer Wiring When Connecting a 4 Flat Vehicle Side to 4 Flat-5 Wire Trailer
I have a 2001 Isuzu Rodeo and was recently trying to connect the connector wires to my trailer. My Rodeo is setup to use a 4 flat female end that runs to 4 wires Ground, Tail, L Turn, R Turn to a converter that connects the 4 wires of the end...
Finding Installer for Curt Hitch on 2009 Kia Rondo
A Curt Trailer Hitch Receiver for a Kia rondo 2009 what car brands aré compatible to install the tráiler Hitch | Hey Adrian, I attached a link to an installer locater that you can use to find someone to install the Curt hitch part # C11031 on...
Trailer Hitch and Wiring for 2009 Mercedes R320 Diesel
I have a 2009 mb R320 diesel w251 . The information on the web site indicates the class 2 trailer hitch and separate wiring packages are for a r350 MB the wiring package is with brake controller and 7 way. Can to clarify the correct products...
Replacement Hardware For Draw-Tite Trailer Hitch For 2014 Nissan Maxima
I bought your kit for my 2014 Nissan Maxima and before the installation I got divorced and moved into a new place, during the move I lost the hardware kit to install this on my vehicle so you sell the hardware kit separately? | Hey Richard, Well...
Will Firestone Coil-Rite Air Helper Springs Fit 2017 Nissan Maxima
does it fit nissan maxima 2017 model ? and is there extra valve connector as I want to keep some extra spare for it | Hello Mohamed; the Firestone Coil-Rite Air Helper Springs # F4105 will fit your 2017 Nissan Maxima. They do not come with...
Parts Needed to Add Brakes to 1992 Coleman Arcadia Pop-Up Camper
I want to add brakes to my 92 Coleman Arcadia pop-up. I am looking for the correct hub/drum and electric brake assemblies. The wheel bolts are 5 on 4 1/2 and the tires are Carlisle USA Trail 20.5x8-10. The current axle includes a square flange...
Can a 3-Wire to 2-Wire Trailer Wiring Harness Converter be Bypassed
can i by-pass a 3 to 2 wire taillight converter in any way | The only way to bypass a 3-wire to 2-wire trailer wiring harness converter (assuming your vehicle has a 3-wire or separate tail light system) would be to convert your trailer to a...
Tallest Rise 1-1/4 inch Hitch Ball Mount Availability
My kayak trailer needs a 22inch height to top of ball for the tongue to be level. My 1 1/4inch receiver goes to 13.25inch inside of top so I need 8.75inch rise to top of ball from that. The C45024 ball mount gives 5inch rise, so I need 2.75inch...
Diagram of the Portion of the Fascia that Needs Trimmed to Install Curt Hitch # C13103
do you have a sketch of how much to trim do you cut around hitch support bar ? | I attached a copy of the installation instructions for the Curt hitch # C13103 which is confirmed your 2007 Mercedes R350. The installation instructions have...
How Can I Carry 50lb Ebikes On The Roof Of My Car
We have a 2021 santa cruze heckler and a 2021 giant stance e2. Will these bikes fork mount and will the carrier handle the weight? Each bike is approx 50 lbs. | Your ebikes weight is one of the limiting factors in carrying them on the roof of...
Replacement Water Valve for Dometic 510+ and 2010 Series RV Toilet
Will this valve fit the 510+ and the 2010 models I’ve identified our toilet by the measurements and there so close it could be either one I’m pretty sure it’s the 510+ | Yes, the Replacement Water Valve for Pedal-Flush Dometic RV Toilet # DOM55FR...
Replacement RV AC Unit Recommendation for Dometic Duo Therm
Good afternoon, In looking for some information re: my Rv DUO THERM COMPATIBLE RV ROOF TOP UNIT! Can you please advise. I’d like to find a direct plug and play w/ heat Thx ***Please see attached information on my current unit. Current...
Should Radial or Bias Tires be Used for a 3500lb GVWR Pop Up Camper Trailer
Vehicle - 2011 Coleman Sun Valley pop up camper. Fully loaded - 3500lbs I cant seem to figure out which tire to get. It seems there is much debate on trailer tires, whether to get radials or bias ply. My stock tires are Kenda ST185/80D13-D and...
Where is Connector Found on 2001 Isuzu Rodeo for Installing Hopkins Trailer Wiring Kit HM43215
I cannot see the plug you guys talk about in the jack compartment, however there is a similar plug on the bottom beside the spare tire is that the correct plug, and do I have to do any other connections? | The plug you have found is the correct...
Will the Swagman Chinook 2 for 1-1/4" Hitches Work With Carbon Fiber Frame Bikes
I am looking at Swagman chinook bike rack to transport our carbon bike, i need a class 1 compatible rack. The review is excellent on eTrailer, but looking at review at other sites, many has express that this trailer is very wobbly and could...
4-Way Trailer Wiring Recommendation for 2002 Isuzu Rodeo
HI first Id like to thank you for you time to answer my question. Ok I have a 2002 Isuzu Rodeo and I want to install a 4way trailer conception. But I only see a connecter with 2 wires one hot and on ground I believe they are the running lights...
Is Cutiing Required for Installation of the Mercedes-Benz R350 Trailer Hitch # C13103
I would like to know if there is any cutting of the oem bumper required in order to fit your trailer hitches? | You will not need to cut the OEM bumper for installation of the Curt Trailer Hitch, item # C13103, for the 2008 R350 by Mercedes-Benz....
Compatibility of Curt Euro-Style Ball Mount w/ Draw-Tite Class I 24796 on 2010 Nissan Maxima
Hi I noticed when the Curt was installed on the Maxima the height was 10 and1/4 inch and the receiver was set back 7inch I would like to install the Draw Tite hitch and use the Curt euro mount receiver bar 1and7/8 for my 2010 Maxima and wanted...
Trailer Hitch for a 2012 Mercedes R350 BlueTec
Will this hitch also fit the Mercedes 2012 R350 Blue Tech diesel model? Also, where is the best place to get the hitch installed once I buy it? I doubt that a dealer would do the work but I am afraid to trust non-Mercedes technicians, especially...
Trailer hitch for a 2004 Isuzu Rodeo with 3.5 Liter Engine
my is 2004 rodeo 3.5 liters wish i will use | The only trailer hitch that will fit the 2004 Isuzu Rodeo with 3.5 liter motor is Curt hitch # C13235. But in order for this hitch to fit your Rodeo must have the rear door mounted spare tire. It...
Filter Your Search
Contact and Help