Why Choose a Powered Taillight Converter Over a Non-Powered Model
What dictates the need between using a powered Tail light convertor Vs a non powered? | There's a couple of factors that determine that. On older vehicles, very few vehicles needed a powered converter, because the vehicle's electrical system...
Finding Installer for Curt Hitch on 2009 Kia Rondo
A Curt Trailer Hitch Receiver for a Kia rondo 2009 what car brands aré compatible to install the tráiler Hitch | Hey Adrian, I attached a link to an installer locater that you can use to find someone to install the Curt hitch part # C11031 on...
Replacement Control Panel for Lippert Leveling System with Module 175226
What touch panel will work with Lippert leveling control 175226/12656 ? | If you have the module part # LC175226 the correct replacement touch panel would be the # LC421484. |
Parts Needed to Add Brakes to 1992 Coleman Arcadia Pop-Up Camper
I want to add brakes to my 92 Coleman Arcadia pop-up. I am looking for the correct hub/drum and electric brake assemblies. The wheel bolts are 5 on 4 1/2 and the tires are Carlisle USA Trail 20.5x8-10. The current axle includes a square flange...
Does the UFP A-60 Surge Brake Actuator Require Lubrication on Inner Slide Member
Does the ufp a60 actuator need any lubrication on any of the of the moving parts on the inner slide? | I looked up the manual online for the UFP A-60 Surge Brake Actuator and found the following bullet points for greasing. "Lightly grease rear...
Replacement Jack For 2001 Stratos Bass Boat Trailer
I have a 2001 Stratos Bass boat with a Fulton center bolt swivel jack onto a welded plate on the trailer. I would like to upgrade to the Fulton F2. My holes on the plate are 3X3 on center. Will the F2 work? Can I send you picture? Thank You...
Installation Instructions for Wiring a 2008 Volkswagen Rabbit to Tow a Trailer
My question is about the electical hook-up. Can I splice a 4-flat connector directly into the wiring harness, or do I need some kind of powered module dure to the fact that it6 haqs LED lights? | Due to the MX (Multi-Plexed) wiring system on...
Why is a Stabilizing Strap Recommended on Curt Hitches and what is Meant by Non-Trailer Load
What is meant by stabilizing straps for non-trailer loads? | Non-trailer loads are hitch accessories like bike racks and cargo carriers. Basically anything that is not a trailer that you could put on a hitch. Curt recommends you use a Curt Trailer...
What is the Battery Life for Hopkins Wireless Magnetic Tow Lights
What is range of battery life for these lights? The check battery level indicator light every 2 hours statement has me concerned. I drive for much longer stretches than that and dont wish to carry excessive spare AAs or replace them every couple...
Highest BTU Rating Available for Camco Olympian Wave Heater
Hi, I would like to know if the CAM57351 heater is CSA Canadian Standard Association approved. Also, do you have another propane heater option with higher BTU? I am looking for a 10,000 to 12,000 BTU heater. Thanks, | The highest BTU rated...
Does The GE Appliances RV Refrigerator GE58FR Come With A Mounting Bracket?
Does this with mounting brackets? | Hello Raymond, thanks for reaching out. The mounting brackets are not included with the GE Appliances RV Refrigerator # GE58FR. It requires a GE approved top bracket part BMT-GPV10. This is not something we...
Trailer Hitch Recommendation for a 2007 Kia Rondo
I am looking for a trailer hitch for a Kia Rondo that was manufactured in Dec, 2006. I dont see one in your listing earlier than 2007. Thank You | That is because you most likely have a model year 2007 Kia Rondo that happened to be built in...
Trailer Hitch and 4-Way Wiring Recommendation for 2018 Mitsubishi Eclipse Cross
I need a hitch and 4 wire harness for a 2018 mitsubishi eclipse cross | For your 2018 Mitsubishi Eclipse Cross we have the Curt hitch # C13273 which is a confirmed fit and then for 4-way wiring you'd want the part # C56296 and you'd be set. |
Recommended Trailer Hitch Receiver for 2011 Kia Rondo
I am looking for a trailer hitch for my KIA Rondo 2011. Do you guys have anything for this models Thanks | For a trailer hitch that fits your 2011 Kia Rondo we have the Draw-Tite Trailer Hitch Receiver # 36525. This is a custom fit Class I...
Troubleshooting Rhino-Rack Roof Rack Installation on 2018 Mitsubishi RVR Flush Rails
Ive tried to install the kit of the SX031 legs on my 2018 RVR, but if you look at the pics those legs are not straight on the flush rails so when I have the bars on them then they dont fit anymore... Am I doing something wrong or I got the wrong...
Trailer Hitch Mount Bike Rack Recommendation for a 2008 Kia Rondo
I just purchased a hitch and bicycle rack for my 2008 Rondo Kia .. When I put a bike on the rack the tires almost touch the ground and if I go down a drive way they do.. Is there a rack extension so I can raise the rack up about 3 or four inches.....
Is Trimming of the Foam Absorber Required for the Curt Hitch On a 2010 Mini Cooper Convertible
have a question about hitch and hard form . I removed the bumper today for preparation for hitch installation. The bumper has the hard foam but it is wedge between the front and back metal bumper with a full metal back hard foam cannot be...
What is the Pin Diameter of 4-Leaf Double-Eye Spring for 4,000-lb Trailer Axles - 26" Dacromet
What is pin diameter on e48sr leaf spring? | The 4-Leaf Double-Eye Spring for 4,000-lb Trailer Axles part # e48SR is designed for a 9/16" diameter bolt like the Zinc Shackle Bolt with Locknut part # TRFA73Z916DLNZ. If you were to remove the...
Aero Bar Rhino Rack Roof Rack that Fits 2009 Volkswagen Rabbit 5 Door Hatch
Hello, I am looking at RR56RR for my 2009 Volkswagen Rabbit 3 door. Your site says it will fit but when I use the part number RV0230B into rhino racks site it states its only for the 5 door car. Which is correct? I really want these for my...
Wiring Harness With Easy Install For 2009 Kia Rondo
I am interested in the Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector for a 2009 Kia Rondo. One of the issues I see in the reviews is that the green wire from the drivers side to the passenger side can be too short....
Troubleshooting Turn and Brake Lights not Working with Running Lights on, 2009 Volkswagen Rabbit
I have the same problem than the VW GTI guy. After I have wired the kit according to the 2-wire method into my 2009 Rabbit, turn and stop light are working as long as the running light is not on. I have tried also the different 3-wire methods...
How to Prevent Exhaust Components from Contacting the Trailer Hitch
I purchased the replacement CURT trailer hitch hardware from eTrailer for this hitch and installed the 11074 on my 2009 4DR Rabbit. However - after install, I now experience a lot more noise at low RPMs. Theres vibration being transmitted back...
Trailer Hitch and Bike Rack for 4 Bikes for a 2018 Mitsubishi RVR
I have a 2018 RVR. Can you recommend a hitch for a bike rack, 4 bikes, and a bike rack? No towing. And I don't want to have to use any straps if possible. | I will be happy to help. For your 2018 Mitsubishi RVR I recommend etrailer Trailer Hitch...
Hitch and Bike Rack Recommendation for a 2009 Volkswagen Rabbit
Hello Looking for bike rack. Drive 2009 VW rabbit. Want simple rack, easy use, no scratch car, two adult bikes 1 womens. Thinking of getting hitch. Sort of new to biking. Dont want to spend a ton of money, but also dont want to worry about...
Filter Your Search
Contact and Help