Why Choose a Powered Taillight Converter Over a Non-Powered Model
What dictates the need between using a powered Tail light convertor Vs a non powered? | There's a couple of factors that determine that. On older vehicles, very few vehicles needed a powered converter, because the vehicle's electrical system...
I’m looking for a rear light that is 10” x 4” , do to show or can direct me in the right direction, also does this “ DG52720PB- LED Trailer Light w/ Reflector - Brake, Tail, Turn - Surface Mount - Rectangular - Red “ come chrome | Hey Sam! Great...
Which Kat's Block Heater Fits 2025 Mitsubishi Outlander SE 2.5 Liter
Will this heater work, without modification, on my 2025 Mitsubishi Outlander SE? Please confirm the location for this vehicle as well. | Hey James, yes the Kat's Heater part # KH11812 that you referenced is a confirmed fit for your 2025 Mitsubishi...
Can a Taillight Converter Module Go Bad After Working Properly for Months
Is it possible for the Circuit Protected Modulite Powered Taillight Converter to go bad? I installed this several months ago and now it does not work. Using a test light, all circuits work beforeinch the converter, but nothing works afterinch...
Trailer Wiring Recommendation for 2006 Mazda Tribute That Doesn't Require Finding Relay Location
I saw on a post it said the relay would have to be installed in a block behind the dash please explain | While I have a much easier trailer wiring solution than the # 40455 that you referenced for your 2006 Mazda Tribute there is a good chance...
Recommended 4-Way Wiring Harness and Connector for a 2005 Mazda Tribute
I have a 2005 Mazda Tribute with a 4-pin harness plug that has a rubber sleeve that mounts into a metal bracket. The plug is intermittent, and I need to replace it. I can send a photo of the plug. I want to know if you have this type of...
Does The GE Appliances RV Refrigerator GE58FR Come With A Mounting Bracket?
Does this with mounting brackets? | Hello Raymond, thanks for reaching out. The mounting brackets are not included with the GE Appliances RV Refrigerator # GE58FR. It requires a GE approved top bracket part BMT-GPV10. This is not something we...
Installation Instructions for Wiring a 2008 Volkswagen Rabbit to Tow a Trailer
My question is about the electical hook-up. Can I splice a 4-flat connector directly into the wiring harness, or do I need some kind of powered module dure to the fact that it6 haqs LED lights? | Due to the MX (Multi-Plexed) wiring system on...
What is the Battery Life for Hopkins Wireless Magnetic Tow Lights
What is range of battery life for these lights? The check battery level indicator light every 2 hours statement has me concerned. I drive for much longer stretches than that and dont wish to carry excessive spare AAs or replace them every couple...
Why is a Stabilizing Strap Recommended on Curt Hitches and what is Meant by Non-Trailer Load
What is meant by stabilizing straps for non-trailer loads? | Non-trailer loads are hitch accessories like bike racks and cargo carriers. Basically anything that is not a trailer that you could put on a hitch. Curt recommends you use a Curt Trailer...
How To Wire 6-Way Square Connector on 2000 Viking Popup to 2001 Mazda Tribute With 4-Way Flat
Is there a ready made connecting harness between 2000 Viking popup 6-Way square and 2001 Mazda Tribute 4-Way flat? I do not need anything other than lights so the six way is not necessary. Thanks. | I do have a few solutions to wire your 2000...
Replacement Jack For 2001 Stratos Bass Boat Trailer
I have a 2001 Stratos Bass boat with a Fulton center bolt swivel jack onto a welded plate on the trailer. I would like to upgrade to the Fulton F2. My holes on the plate are 3X3 on center. Will the F2 work? Can I send you picture? Thank You...
Items Needed to Tow a Trailer with a 2011 Lexus RX350 Without Tow Package
I bought a 2011 RX350 Canadian version that was not ordered with the tow package. What do I need to install to properly tow our 2500 lb boat? | To tow your boat trailer with your 2011 Lexus RX350, you will need a trailer hitch, wiring harness,...
Which Fuse of 2005 Mazda Tribute with Tow Package for Activating Circuits
I have a 05 Mazda tribute with the towing go plug in need to know what fuse I need to make it work or relay and where does it go in fuse box | From customers we've learned that the fuse slot number 1 is the one associated with activating the...
Replacement Top Channel Cover For Thule Aeroblade Load Bars
I see the replacement strip for the Aeroblade is listed at only 59. Is there a different part number for the ARB60? | The Replacement Top Channel Cover for Thule AeroBlade Load Bars - 59" Long - Qty 1, # 852-5402-005 is the correct part for...
Trailer Hitch and 4-Way Wiring Recommendation for 2018 Mitsubishi Eclipse Cross
I need a hitch and 4 wire harness for a 2018 mitsubishi eclipse cross | For your 2018 Mitsubishi Eclipse Cross we have the Curt hitch # C13273 which is a confirmed fit and then for 4-way wiring you'd want the part # C56296 and you'd be set. |
Trailer Wiring Harness for a 2008 Mazda Tribute without Factory Tow Package
Have bought your 118251 only to find my car does not have relays and is not wired for relays. Can I buy the other parts I need to make my 1 18251 into your 118551 Thanks | If your 2008 Mazda Tribute did not come with the factory tow package...
Is Trimming of the Foam Absorber Required for the Curt Hitch On a 2010 Mini Cooper Convertible
have a question about hitch and hard form . I removed the bumper today for preparation for hitch installation. The bumper has the hard foam but it is wedge between the front and back metal bumper with a full metal back hard foam cannot be...
Roof Rack for 2005 Mazda Tribute With Raised Side Rails for Rooftop Tent
Hello. I have a Mazda Tribute 2005 and i would like to put a roof tent in there. I only have the original racks and i dont know if changing them would be ok or i would be still on risk? Another company told me even changing them is not safe... Thank...
Troubleshooting Rhino-Rack Roof Rack Installation on 2018 Mitsubishi RVR Flush Rails
Ive tried to install the kit of the SX031 legs on my 2018 RVR, but if you look at the pics those legs are not straight on the flush rails so when I have the bars on them then they dont fit anymore... Am I doing something wrong or I got the wrong...
How to Prevent Exhaust Components from Contacting the Trailer Hitch
I purchased the replacement CURT trailer hitch hardware from eTrailer for this hitch and installed the 11074 on my 2009 4DR Rabbit. However - after install, I now experience a lot more noise at low RPMs. Theres vibration being transmitted back...
Troubleshooting Turn and Brake Lights not Working with Running Lights on, 2009 Volkswagen Rabbit
I have the same problem than the VW GTI guy. After I have wired the kit according to the 2-wire method into my 2009 Rabbit, turn and stop light are working as long as the running light is not on. I have tried also the different 3-wire methods...
Aero Bar Rhino Rack Roof Rack that Fits 2009 Volkswagen Rabbit 5 Door Hatch
Hello, I am looking at RR56RR for my 2009 Volkswagen Rabbit 3 door. Your site says it will fit but when I use the part number RV0230B into rhino racks site it states its only for the 5 door car. Which is correct? I really want these for my...
Replacement Curt Trailer Hitch Hardware Kit for a 2009 Volkswagen Rabbit
Hi - I recently received a CURT C11074 Trailer hitch for the 2009 VW Rabbit from a friend who no longer has their MK5 rabbit. Is it possible to purchase *only* the replacement mounting hardware for this specific mount instead of the generic...
Filter Your Search
Contact and Help