Will The 16 Inch Wheel Masters Wheel Covers Fit My 2WD Ford F-350?
Will that set of 4 fit 1997 ford f350 2 wd? There 16 inch and 8 lug steel wheels but he said the front would need to be 3 inches deep and rear would need to be 4 inches deep? | I went back into the warehouse and measured this product myself....
1997 Ford F-350 Trailer Brakes Locking Up When Harness Is Plugged In
I have a Gooseneck horse trailer that we pull with a 97 F-350. Never had any trouble with the trailer brakes until yesterday. When I plugged in the harness the brakes immediately engaged. I found the ground wire on the truck battery was loose,...
Correct Blue Ox Avail Tow Bar To Roadmaster Direct-Connect Base Plate Kit Adapter
I need an adapter to connect the Roadmaster 458-1 mounted on a 97 Ford F-250 Supercab 4x4 diesel to a Blue Ox Avail tow bar BX7420. The QandAs fir the base plate discuss using a BX88185 adapter. Im confused however because the Blue Ox Avail...
Will The Curt Trailer Hitch Receiver # 14001 Fit With Aftermarket DMI Bumper on 1997 Ford F-250?
i have a 1997 ford f 250 hd with a DMI SPRING loaded bumper/ hitch. I removed the center spring hitch s it always was to high for trailers, Will this 14001 bolt under this DMI bumper that remains | You are going to have roughly 8-5/8" from...
Fitting to Allow Your Grill with Type-1 Connector to Connect to Standard 1 Pound Cylinder.
lost my attachment to connect a 1lbs to my bbq for this... https://www.etrailer.com/Grills-and-Fire-Pits/Faulkner/FR51322.html can I buy a new one? | Thanks for the picture of what you need. I see your grill came with a special regulator that...
Are Westin Signature Series Nerf Bars for a 1997 Ford F-250/F-250 Still Made
Do you carry the Westin 25-0620 nerf bars | The Westin Signature Series Round Nerf Bars 25-0620 have been discontinued (we did carry them) but we do have some other options if you're looking for nerf bars to fit the 1997 Ford F-250/F-350 you...
Trailer Wheels that are Made in USA that are 14 inch Diameter
Where are the Americana Trailer wheels manufactured? | They are made in China. Dexstars are made in USA if that's what you are looking for. | 14 inch and I believe 5 x 4.5 | I attached a link to a page that has all of the Dexstar trailer wheels...
Determining Correct 2 Lift For 2005 Keystone Sprinter
I have a 2005 keystone sprinter. I need to lift it approximately 2 inches to make it ride level and give me the proper clearance above the bed rails of my truck. Do you have a kit that would work for me? | There are a few options when it comes...
Which Westin Fey SureStep Rear Bumper Fits 1997 Ford F-350
I have a 1997 ford f350 XL and the original bumper was damaged will the bumper # 76001 fit? | I have a similar chrome bumper that fits your 1997 Ford F-350 but the # 76001 is not the correct part number. Instead you'd want the Westin Fey SureStep...
Correct Nerf Bars for 1997 Ford F-250 HD SuperCab Pickup
Will these running boards mount onto my 1997 Ford F-250 HD Supercab Longbed? It is an OBSOld Body Style which is square bodied, not round bodied. | For your 1997 Ford F-250 HD with the SuperCab you can use the 3" Round DeeZee Nerf Bars # DZ3700291...
Will Curt Front Mount Trailer Hitch # 31310 Fit 1997 Ford F-450 Super Duty Diesel
Will this particular hitch fit a 1997 ford F-Superduty diesel? F450. Thanks. | According to my technical contact at Curt, the Curt Front Mount Trailer Hitch # 31310 that you referenced will fit your 1997 Ford F-450 Super Duty as long as it is...
Are There Air Bags for a 1997 Ford F-350 with In-Bed Hitch
Looking for a set of airbags for my 97 f350 that won’t interfere with my BandW turn over ball | I do have suspension enhancement options for a 1997 Ford F-350 but air bags won't be one of them as they all mount in the same spot as the in-bed...
Recommended Rear Suspension Enhancement Springs for 1997 Ford F-250 Heavy Duty
I have a 1997 F250HD, Diesel, their short bed which is 7 feet, and a Pull Rite fifth wheel. I would like to install a set of air bags but would like a little help on which set up would be best. I looked at the Firestone set as well as the Air...
Engine Oil Heater for a 1997 Ford F- Series Pickup Truck with a 7.3L Diesel Engine
Will it work on 1997 ford 7.3 desial engan | The Kat's Heaters Engine Oil Dipstick Heater part # KH15200 is a universal fit item that will work on a variety of different makes and models. There are only two requirements for the dipstick heater...
7-Way Replacement Plug For 1997 Ford F-350
I have a 1997 Ford 350 XLT Powerstoke that had the 7 Way RV Trailer Wiring Plug its wired from the factory, its just worn out so im looking for a replacement plug and bracket. Could you please provide me with the link to the replacement plug...
Troubleshooting Trailer Brakes That Do Not Grab Evenly On Both Sides
Wondering why is my Travel trailer brakes are not engaging evenly? The left side are grabbing stronger than the right side, They are adjusted evenly. | If you're certain that your trailer brakes are adjusted properly, then you likely have a...
Rail Kit for 1997 Ford F-250 to Allow Use of Curt Q25 Fifth Wheel Hitch
Curt q25 is being listed as only being compatible on newer Fords. Question is, if I use universal top mounted bed rails, then wouldnt it fit my 97 f250? Thx | Yes, if you installed an above-bed mounted fifth wheel rail kit in the bed of your...
Distance Between Support Arms of Solera 16 foot Power Awning LC729486
Can you tell me the wall mounting point measurements? Meaning the screw holes center-to-center because I am mounting this on an enclosed race trailer and want to make sure the studs of the trailer would align. Otherwise I will have to fabricate...
Wiring to Brakes on Trailer Being Double Towed
Fifth wheel RV double pulling. I have brakes on fifth wheel RV, how do you get brakes to Second trailer . | To get brakes to your second trailer you will want to use 7-Way Molded Trailer Plug with Junction Box # 277-000141 on your second...
Do the Westin Fey Surestep Deluxe XLT Rear Bumpers Hold Up Well Against Rust
does your bumpers hold up well against rust | Westin Fey Surestep Deluxe XLT Rear Bumper # 21007-92230 is made of chrome-plated steel so it will hold up about as well as any other chrome-plated steel component on a vehicle. Since it isn't stainless...
Trailer Hitch Needed for a 1997 Ford F-350 Heavy Duty with a Deep Drop Bumper
I need a hitch for my 1997 f350 with a deep cowboy bumper. I also need to tow with my camper in the bed of the truck. Is there a solution that won’t cost me a lot? Thanks, | The Curt 3-Piece Trailer Hitch Receiver # C15511 that you referenced...
Brake Controller and Trailer Wiring for 1997 Ford F-350 Utility Body Without Factory Wiring
NO TRAILER PLUG AT REAR OF BODY, HAVE FOUND 4 WIRES TAPED TOGETHER ON INSIDE OF FRAME NEAR FUEL TANK, THESE CARRY SIGNAL FOR TURN AND TAIL, BUT SHOULD THERE BE ANOTHER PLUG ON THIS CHASSIS THAT ALREADY HAS PIGTAIL TO MATCH AND PLUG AND PLAY....
Multi Fit Hitch for RV with 5,000 lb Towing Capacity
I have a Class C Motorhome 28ft and I am looking for a new hitch that will support 5000lbs. My main frame is a C beam and was wondering if this is the correct hitch Multi-Fit Motorhome Trailer Hitch, 24 - 46 wide Item # 5350 Draw-Tite logo Thanks...
Recommended Trailer Hitch With Extension For 1997 Ford F-250 With Camper And Boat Trailer
1997 Ford F-250 4x4, supercab, 7.3 diesel, 8foot bed, air bags. 915 lance camper 96inch long. Is super hitch the only brand that can accept the custom frame mounted rear camper tie downs? I also need an 18-21inch extension. Trailer weight is...
Filter Your Search
Contact and Help