RV Exterior Lights Specs:
Features:
4-1/2" x 2-7/8" x 1". Low-profile dome light illuminates an RV's interior with bright white light. Toggle switch controls power. Durable polycarbonate lens and housing. Surface mount - hardware not included. 2-Wire design.
More Information >LED Strip Lights Specs:
Features:
9" Long x 1" wide x 5/8" thick. Low-profile LED light strip illuminates an interior area. Built-in switch controls on/off function. Surface mount - hardware not included. 2-Wire design. 9 LEDs.
More Information >RV Exterior Lights Specs:
Features:
3" Diameter waterproof utility light with nickel trim ring illuminates your trailer's interior with bright white light. Touch activation makes it easy to switch the light on and off. Surface mount - hardware not included. 2-Wire pigtail.
More Information >RV Interior Lights Specs:
Features:
Use the integrated switch or wire to a light switch to turn the single dome light on and off. Included incandescent bulb and acrylic lens are perfect for brightening up your RV kitchen when doing dishes or your enclosed trailer when loading gear.
More Information >Videos
for RV Interior Lights
Help Articles
for RV Interior Lights
Expert Answers
for RV Interior Lights
I have a solution for you, but the main issue with puck style lights that mount to the surface of your RV ceiling or under cabinets, is that there aren't replacement bulbs available and they aren't really designed to have the bulbs…
view full answer...You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better…
view full answer...From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…
view full answer...We carry replacements that could integrate into your Dometic AC system, but before purchasing anything you'll need to remove the cover of your air distribution box under the unit you're wanting to replace and look for the wire harness that…
view full answer...The 12v accessory pin from the 7-way would need to be connected to the battery in order to charge it so you'd first need to make sure it was actually wired that way since not every manufacturer does. That being said the trickle charge coming from…
view full answer...From what I could find out about your current circuit board, the Atwood Replacement Control Panel #AT91367 will be a direct replacement.
view full answer...The 125255UC seal has a 1.249" ID and a 1.983" OD and for that our part #34823 will be the correct replacement.
view full answer...For 12v Vanity lighting we only offer the following products which are all satin nickel: Item #277-000324, Item #277-000446, Item #277-000322, and Item #277-000429. I've attached a link to the RV lighting page as well.
view full answer...While we do not carry the L9100 light you are asking about, or replacement parts for it, we do have similar replacement options such as the 2" Recessed Halogen Puck Light with Frosted Glass, #277-000125 and the LED RV Puck Light - Recessed Mount…
view full answer...The Opti-Brite LED Interior Light part #ILL08COB and part #ILL10CCB are idenical lights for the exception of the number of diodes they contain. The light ending in "COB" contains 8 diodes whereas the light ending in "CCB" has 10…
view full answer...An E1 code on the Fogatti RV Tankless Water Heater, #LSB64FR, is indicating an ignition failure or accidental flame off during ignition. If you had this professionally installed, I suggest you return to the installer for troubleshooting and repair.…
view full answer...The 15,000 Btu Furrion air conditioner is what I would recommend and what I have on my trailer. Since it is an enclosed trailer I'm guessing you want the manual distribution box. You can choose from the following based on color: -Furrion Chill HE…
view full answer...