2008 Keystone VR1 TT Toy Hauler RV Antenna and Radio

With your trailer you should have been sold a Fastway e2 Weight Distribution #FA92-00-1000 as it is for trailers with a tongue weight of 600-1,000lbs. The dealer should have accounted for the additional weight of the battery and propane plus…

The Dexstar Conventional Steel Wheel with Offset - 14" x 5-1/2" Rim - 5 on 4-1/2 - Black #AM20304 you referenced is a conventional wheel that should work with most baby moons. We have baby moons #AM90086 that I can confirm as a fit that…

I spoke with Furrion and found that this is a known issue with the wiring on the side marker cameras #FCE48TASL. A lot of people have been installing the trigger wire in with the power wire instead of running it to the turn signal or just capping it…

That is a great question. Both of those are great weight distribution hitches. Between the two, I prefer the Reese Dual Cam II over the Strait Line. The Dual Cam uses an L-bracket to attach to the frame, instead of a chain and lift bracket.…

Hello Jerry, We have a rack that will work for you, but the Swagman Escapee RV Bike Rack #S39SR will not work with bikes that have fenders. I attached an image to show how the bike rack clamps down on the wheel, the fender would be in the way. The…

Hey Steven, so I am not sure why MORryde did it this way but you can't add their lift assist setup to the versions of the StepAbove steps that didn't come with it. Only solution would be an all new step setup that has them like the part…

Hey David, from previous customers of ours who have the same 2020 Keystone Raptor 424 we have determined that your pin box style is the Lippert 1621 which means for a Gen-Y gooseneck adapter you'd want the #GY38FR that you referenced.

We do have Jensen In-Wall Antenna - AM/FM - 6' Long #AN140 which is 6 feet long total, but it comes with a threaded on wire loom to hardwire to an antenna, and it can be removed which leaves you with about 3 foot long cable that would work for…

To flat tow your 2018 Jeep Wrangler JL you will need to start with compatible base plates; because you have a Blue Ox tow bar and assuming you have the standard factory bumper the best option is the Blue Ox Base Plate Kit #BX1139 which will be…

Based on your description it sounds like you have the Replacement New-Style Linc Analog Remote - 5 Function #LC292614. In order to sync this remote you need to start by pressing and holding the momentary push button on the receiver. Next, press the…

Since your trailer has the bracket #FRCBRKT-BL that would mean your trailer has the Furrion pre-wiring which is very common for newer RVs. The part #FOS43TASF is a fit for this and would be a really easy install. This gives you a monitor with a 4.3…

The Furrion camera system we have is a closed system and would not be compatible with the in-dash display so you would need to purchase GM's camera system to be able to connect to your display instead of having another monitor. If you do end up…