Troubleshooting An RVS RV Camera That Stopped Working

Updated 12/04/2025 | Published 03/04/2023

Products Featured in This Question

Rear View Safety Backup Camera System - 4 Camera Setup - Quad View Monitor

(39)

$750.47

Rear View Safety Backup Camera - Weatherproof - Night Vision - RCA Connectors

(1)

$139.91

Question:

I have a 4 camera system on my class A The ground camera stopped working. Checked the wiring and it seems way more complicated than the diagram Can someone walk me through what I should be looking for?

asked by: Eric H

Expert Reply:

The Rear View Safety Backup Camera System # RVS-062710 is a pretty much closed system with each component having a connector to connect to the wiring instead of splicing. Most likely the camera that isn't working has a loose connection so you'd want to start by removing the camera from your motorhome and checking the connector to ensure it's fully secured. From there you would need to trace the wire up to monitor checking every connection point for anything loose.

If you find each connection point is good then the camera itself might be the issue and will need to be replaced with part # RVS-777. These cameras take a lot of abuse and some don't end up making it. I've seen quite a few with water damage that end up just having to be replaced to restore the view. Having ran wire through multiple motorhomes I completely understand the struggle of tracing wire through walls and sympathize with you for the task you have ahead of you.

expert reply by: Kevin C

Carmen

8/28/2024

My pathfinder rv camera stopped working while I was traveling. Led light doesn't work either.

Kevin C.

8/28/2024

@Carmen If your camera stopped working then I would first check to see if it has power running to it with a multimeter. If not then you probably have a blown fuse and will need to restore power for the camera to function again. Since your light is out too I'm assuming they're both on the same circuit and the fuse is blown. If this is a camera on the back of your RV then make sure you have your running lights on in the Pathfinder. You can also test the 4-pole or 7-way connector to see if the signal is coming through. If not, then you most likely have a blown fuse on the Pathfinder or the wiring could've been damaged.

Ray

12/4/2025

I purchase Rimoody 9” inch with 4 cameras. I only have the back camera hook up the picture is reverse left and right is wrong you can email me or call 705-561-0043

Jesse M.

12/4/2025

@Ray Hey Ray. The picture being reversed is likely just a setting. Those monitors have image flip options so if you go to the settings on your monitor you should be able to fix that. Just hop into the monitor’s menu usually the “M” or “Menu” button and look for the image settings for the rear camera. You’ll see options like Mirror, Flip, or L/R. Right now the mirror option is turned on, which swaps left and right. Just toggle that setting off for the rear channel and the picture will straighten out. Quick fix, no rewiring needed.